Search

Power control is becoming increasingly essential for the fifth-generation (5G) and beyond systems. An example use-case, among others, is the unmanned-aerial-vehicle (UAV) communications where the nearly line-of-sight (LoS) radio channels may result in very low signal-to-interference-plus-noise ratios (SINRs). The authors in (Chiang et al., 2007) proposed to efficiently and reliably solve this kind of non-convex problem via a series of geometrical programmings (GPs) using condensation approximation. However, it is only applicable for a small-scale network with several communication pairs and practically infeasible with more (e.g., tens of) nodes to be jointly optimized. We therefore in this paper aim to provide new insights into this problem. By properly introducing auxiliary variables, the problem is transformed to an equivalent form which is simpler and more intuitive for condensation. A novel condensation method with linear complexity is also proposed based on the form. The enhancements make the GP-based power control feasible for both small- and especially large-scale networks that are common in 5G and beyond. The algorithm is verified via simulations. A preliminary case study of uplink UAV communications also shows the potential of the algorithm. [ABSTRACT FROM AUTHOR]

Interference alignment (IA) is a promising technique for interference management and can be applied to spectrum sharing in cognitive radio (CR) networks. However, the sum rate may fall short of the theoretical maximum, particularly at low signal-to-noise ratio (SNR), and the quality of service (QoS) of the primary user (PU) may not be guaranteed. In addition, power allocation (PA) in IA-based CR networks is largely ignored, which can further improve its performance. Thus, in this paper, PA in IA-based CR networks is studied. To guarantee the QoS requirement of the PU, its minimal transmitted power is derived. Then, we propose three PA algorithms to maximize the throughput of secondary users (SUs), the energy efficiency (EE) of the network, and the requirements of SUs, respectively, while guaranteeing the QoS of the PU. To reduce the complexity, the closed-form solutions of these algorithms are further studied in detail. The outage probability of the PU according to its rate threshold is also derived to analyze the performance of these algorithms. Moreover, we propose a transmission-mode adaptation scheme to further improve the PU's performance when its QoS requirement cannot be guaranteed at low SNR, and it can be easily combined with the proposed PA algorithms. Simulation results are presented to show the effectiveness of the proposed adaptive PA algorithms for IA-based CR networks. [ABSTRACT FROM AUTHOR]

In wireless communication systems with multiple users, the near–far effect and the cochannel interferences decrease the spectral efficiency and system performance. An efficient known method to combat these destructive effects is to properly adjust the transmit powers. A practical and efficient way for power control (PC) in cellular communication systems is the autonomous distributed PC (DPC). In this method, the transmit power of each link is independently modified based on the received signal-to-interference-plus-noise ratio (SINR) reported from the other side of that link. It is known that in a perfect scenario where the reported SINRs are exact, this algorithm converges to the optimum transmit powers. However, in the case of erroneous SINR reports, the transmit powers deviate from their optimum values. This paper addresses the destructive effect of inaccurate SINR reports on the performance of a DPC algorithm. Then, independent variable step-sizes that update the transmit powers are proposed, and convergence of the proposed DPC algorithm to the optimum solution of the original problem is analytically shown. Additionally, a protocol to adaptively tune the step-sizes in our algorithm, which improves the performance of PC in the presence of inaccurate SINR reports, is proposed. Computer simulations are used to study the performance of the proposed method in terms of both the speed of converges and the steady-state accuracy of link qualities. [ABSTRACT FROM PUBLISHER]

We propose a transmitter beamformer design technique for a spectrum-sharing network with mixed quality-of-service requirement. In particular, the proposed algorithm has the ability to jointly design multiple beamformers, so that a specific subset of users attains certain target signal-to-interference-plus-noise ratios (SINRs) whereas the SINRs of the remaining users are balanced subject to multiple linear constraints. The design framework considered is applicable to both the overlay cognitive radio network (CRN) and the underlay CRN; however, the algorithm is described for the example of an underlay CRN to include a very general mathematical framework. We maximize the worst-case users' SINR of a particular set of users while satisfying the target SINRs of the remaining users subject to the total transmission power and the interference leakage constraints. This algorithm is solved using the uplink–downlink duality and subgradient method. The condition for convergence is analytically derived. The simulation results are provided to validate the optimality and the convergence of the proposed algorithm. [ABSTRACT FROM PUBLISHER]