Search

The distributed Goppa coded spatial modulation (DGC‐SM) scheme is proposed in cooperative scenarios. In the proposed DGC‐SM scheme, the relay chooses the partial information from the source by using the idea of information selection, and then re‐encodes the selected information. At the destination, a distributed Goppa code is obtained corresponding to each selection. In order to get the best possible code, an optimal information selection algorithm is proposed at the relay. In the proposed optimal algorithm, all selections and source message sequences are considered, which results in high complexity. Thus, another optimized information selection algorithm with low complexity is proposed at the relay. To further enhance the capability to get the source information, two efficient joint decoding algorithms called smart decoding algorithm and improved smart decoding algorithm are proposed. Moreover, the bit error rate (BER) performance bound of the proposed DGC‐SM scheme is derived. Through the simulations, the effectiveness of the proposed two optimized information selection algorithms is confirmed. Also, it is observed that the simulation and analytical results closely match at high signal‐to‐noise ratio (SNR). [ABSTRACT FROM AUTHOR]

Frequency‐time selective fading degrades the performance of communication systems, but it also provides an opportunity to collect multipath diversity and Doppler diversity. In this paper, an oversampled grouped‐linear‐constellation‐precoding (GLCP) scheme is proposed for orthogonal frequency division multiplexing (OFDM) systems to extract the diversity inherent in doubly selective fading channels. In the proposed scheme, GLCP is employed to precode the information symbols of OFDM at the transmitter, and the precoded OFDM symbols are oversampled in the time domain at the receiver. A full‐groups maximum likelihood (ML) decoder and a successive group decoder to decode the oversampled OFDM symbols with diversity gains are developed. The successive group decoder combines the group ML decoding algorithm with a block‐decision‐feedback‐equalization (BDFE) algorithm. The proposed scheme can take advantage of both the GLCP scheme and the oversampling scheme to achieve multipath diversity gains and Doppler diversity gains in doubly selective fading channels. Simulation results show that the proposed scheme can significantly improve the performance of OFDM systems in the frequency selective fading channel and the doubly selective fading channel in terms of bit error ratio, indicating that the diversity gains can be greatly enhanced by the proposed scheme in doubly selective fading channels. [ABSTRACT FROM AUTHOR]

This work studies the equalization methods for the reduced zero‐padding version of the orthogonal time frequency space modulation. Here, the focus is on applications in low data rate scenarios such as the Internet of Things, and the case where the number of subcarriers and time slots are small will be considered. First, the system equation is established to model the inter‐subcarrier and inter‐slot interference phenomena. Based on the system model, three sphere‐decoding based equalization methods are proposed. The first method is to directly apply the sphere‐decoding algorithm on the full‐scale system model; for the second method, the transmitter needs to perform the triangular precoding; and for the third method, the transmitter needs to perform the diagonal precoding. Simulation results show that the proposed sphere‐decoding based methods achieve better bit error rate performance than the state‐of‐the‐art methods like message passing, unitary approximate message passing, and variational approximate message passing, especially when the channel has severe inter‐slot interference. [ABSTRACT FROM AUTHOR]

In this study, the authors investigate the use of combined belief propagation (BP), mean field (MF) and expectation propagation (EP) message passing to achieve joint channel estimation and decoding (JCED) for orthogonal frequency division multiplexing where the channel sparsity is exploited, and a low-complexity BP-MF-EP-based JCED receiver is designed. Moreover, comparisons in message updating of state-of-the-art message passing-based JCED receivers are provided to illustrate the merits of the proposed one. In addition, message passing schedules are optimised to achieve better system performance. Simulation results verify the superiority of the proposed combined message passing receiver in terms of both bit-error-rate performance and convergence speed. [ABSTRACT FROM AUTHOR]

The Luby transform (LT) code is the first practical implementation of the digital fountain code, and its utilisation over a noisy channel invokes iterative decoding with soft information. For a good decoding performance, the role of the encoder degree distribution is vital. Especially, when utilising the soft iterative decoder, the bit error rate (BER) performance of the LT code can be improved by increasing the number of the degree-1 encoding nodes and reducing the number of lower-degree variable nodes. This study proposes an efficient LT-code encoding algorithm that satisfies the conditions for improving the BER performance. The proposed scheme applies different priorities for selecting the neighbouring source nodes for given degrees of the encoding nodes. The simulation results demonstrate that the proposed scheme outperforms the existing schemes. [ABSTRACT FROM AUTHOR]

In this study, the authors propose a polar coding (PC) scheme for the power line communication (PLC) system to cope with the impulsive noise and thereby promote the transmission performance. This new error-correcting coding scheme is essentially inspired on a novel conception of channel polarisation. To be specific, via recursively channel combing and splitting, a group of channels with ideal transmission conditions, that is having a capacity of 1, will be constructed to carry the useful information, while the other band sub-channels bear useless information. The decoding performance of PC under realistic impulsive noises is investigated under the condition that the impulsive noise is modelled by a well-known Middleton Class-A model. To mitigate the error propagation caused by sudden strong impulsive noises and further enhance the decoding performance, a matrix interleave operator is integrated. Simulations validate the suggested PC scheme in PLC systems. Compared with another commonly used low-density parity-check (LDPC) coding scheme, the suggested PC scheme, which has the low complexity, can significantly improve the bit error rate (BER) performance of PLC transmissions with impulsive interference. The PC scheme, as demonstrated by simulation results, can be of great importance to practical PLC systems. [ABSTRACT FROM AUTHOR]