Search

The study presents a significant development of an advanced control strategy for stand-alone three-phase induction generators. The system under study consists of a squirrel-cage induction generator driven mechanically by an internal combustion engine and electrically by a fault-tolerant converter coupled with a LC filter. As a novelty, in this study three low-cost electrical contactors are introduced in order to re-arrange the converter topology after a fault occurrence and a proper re-starting procedure is developed, allowing the converter to operate with only two legs. The control architecture is mainly described with respect to this last operating condition, evidencing its intrinsic robustness. The study focuses on the composite control of the converter and the prime mover in order to improve the dynamic assessment of the whole system. The converter control is designed around the sliding mode technique, due to its attractive performance, especially as far as parameter uncertainties are concerned. In order to validate the theoretical framework, this study presents the first ever made experimental tests of this system with reference to a generation unit of about 10 kVA. The results confirm the high capability of the proposed system in regulating voltage and frequency with very good dynamic features.

This study deals with direct torque control (DTC) of induction motor drives when a multilevel inverter is involved. The proposed control technique is finalised to reduce the amplitude of torque oscillations and to improve the motor dynamic response regardless of operating speed conditions while assuring a satisfactory input current distortion. This is achieved by using a special look-up-table built with a novel approach. The control itself is based on the application in each sampling interval of one or two voltage vectors suitably selected, in order to ensure low electromagnetic torque ripple in steady-state operations and fast dynamic behaviour in transient operations. In the algorithm, the converter voltage vectors selection is carried out by using a novel look-up table whose entry points are computed by means of a specialised relation, starting from the outputs of multilevel hysteresis controllers. The suggested method, suitable for a generic multilevel inverter, is detailed for a neutral point clamped three-level inverter. The proposed algorithm is validated by several numerical results, and compared with a DTC algorithm based on a traditional three-speed range look-up tables. Finally, some experimental results, obtained with a scale laboratory setup, are shown, discussed and compared with the numerical ones.