Search

Abstract: In this study, thermal performance of the cooling modules applicable for Par 38 light bulb is investigated. A total of six heat sink modules, including the basic reference design, metal foam, and carbon foam are tested and compared. Tests are performed and analyzed using the transient test method based on JESD51-1 standard. It is found that the thermal resistance from junction to die attach is quite small. By contrast, the thermal resistance of the heat sink dominates the total resistance, and it comprises 55% of the total resistance for the standard heat sink module. With some slight opening on the base plate, the thermal resistance can be improved by approximately 12%. The thermal resistance for the carbon foam having an embedded metal plate shows the least thermal resistance of 1.14K/W, followed by the carbon foam, and then the metal foam. The lower thermal resistance of carbon foam in association with copper metal foam is due to its higher emissivity. In addition to better heat transfer performance as compared to the standard plate heat sink, the utilization of carbon foam and metal foam can also significantly reduce the weight of the heat sink. In this study, the weight of the heat sink can be reduced as much as 33%. [Copyright &y& Elsevier]

In this study experiments were conducted to study the porous thin plate drying process. An analysis was also carried out to determine the moisture transfer coefficients that vary with the moisture content of the plate during drying. The study is useful for analyzing the transient drying process of porous thin plates. Furthermore, energy and exergetic analyses based on the measured results were carried out to determine the dryer performance. It is found that, although the drying rate increases, the energy utilization ratio of the drying process decreases with either an increase in the rate of air flow or an increase in the size of the drying air inlet. The results indicate that a significant amount of the energy provided to the system was lost and not utilized for drying, especially for high drying rate dryers. An exergetic analysis showed that by adjusting the configuration of the air inlet and flow rate, the exergetic efficiency of the dryer can be significantly increased (from 0.5% to 10%). An overall transport phenomena analysis and performance evaluation including the transient moisture transfer coefficients, drying rate, energy utilization ratio, and exergetic efficiency in the current study provide comprehensive and important insights to the thermal physics of porous thin plate drying processes and the design of efficient dryer systems. [ABSTRACT FROM AUTHOR]