Search

This study involves the investigation of the mechanical properties of the extruded tube products with reinforced silicon carbide particulates (SiCp). Finite element analyses are firstly conducted to analyze the plastic flow of the magnesium alloy AZ61 within the die and to investigate the effects of initial billet temperatures on the extrusion loads and final product temperatures. AZ61/SiCp composite ingots reinforced with different weight fractions of SiCp are fabricated by a melt stirring technique. A specially designed die set is used in the extrusion experiments to obtain tubes with uniform thickness distribution in the circumferential direction. The extruded tubes are also heat treated to obtain even better mechanical properties. Finally, tensile tests, Vickers microhardness, tests and microstructure observation are performed on the billets and extruded tubes of AZ61 monolithic alloys and AZ61/SiCp composites. A much smaller grain size and higher tensile strength and hardness are achieved for the extruded AZ61/SiCp composite tubes. [ABSTRACT FROM AUTHOR]

This paper aims to investigate the temperature field evolution of the single track clad in wide-beam laser cladding. By using the birth and death element technique, a 3D transient finite element (FE) model was established to study the temperature field evolution, temperature gradient (G), cooling rate (ε), and solidifying rate (R) of the molten pool. The temperature field results of the molten pool were also validated by the temperature measurement and characteristics of the clad. Meanwhile, the effect of main parameters namely as laser power, scanning speed, laser absorptivity, laser power efficiency, and preheat temperature on the peak temperature of the molten pool and temperature variation rate were discussed in detail. Then, the effect of laser power and scanning speed on G, ε, R, and G/R were also investigated and the corresponding microstructure was analyzed. The results show that from the top surface of the clad to the interface between the clad and substrate, G/R decreases slightly at first and then increases sharply while the cooling rate continues to decrease. Moreover, the peak temperature of the molten pool increases with an increase of laser power, laser absorptivity, laser power efficiency, and preheat temperature, while with the increasing of scanning speed, the peak temperature decreases. [ABSTRACT FROM AUTHOR]