Search

Sintered gears manufactured through powder metallurgy technology contain residual porosity that can make them inadequate for high power supply. Crack propagation is significantly enhanced by both residual porosity and cyclical stresses involving the teeth. The use of densification processes can highly improve their performances, permitting the reduction of the residual porosity. Among the densification processes, the rolling assumes a key-role. The process permits the densification of the tooth flanks, the most stressed parts of the wheel. However, the performances of the rolled wheel depend on several process parameters, whose setup phase requires several efforts and many experiments. Finite element (FE) model can be a helpful tool, allowing a faster estimation of the process parameters, reducing waste and costs linked to the experimental tests. In this sense, FE modelling techniques discussed in literature only cover the simulation of spur gears densification process, since they consist of in-plane 2D finite elements. In this paper, different numerical modelling techniques, based on 2D finite elements, are proposed to simulate the densification process of spur gears and used to perform a tendency analysis to explore the effects of wheelbase reduction between the forming rollers on the material densification. Material densification appeared higher for reduced wheelbases, but an increasing cavity was observed at the tooth root as the wheelbases decreases. Moreover, a FE model based on 3D finite elements is proposed to reproduce numerically the rolling process of a helical gear. The accuracy of the 3D FE model was measured against the results provided by some experimental tests, herein discussed too. A good agreement between numerical and experimental results was observed. [ABSTRACT FROM AUTHOR]

System engineering (SE) methods and principles are nowadays widely adopted in the product development processes, especially in the industrial sector, where saving production time and costs are primary goals. This work describes an application of a particular SE methodology, the V-model-based design, in which the system development lifecycle is divided on the basis of a graphical V-shaped scheme, called V-model. Following this approach, a new concept of charging arm for Robotic Train Inspection Monorail (TIM) of Large Hadron Collider (LHC) at CERN (Conseil Européen pour la Recherche Nucléaire) has been developed. The current charging arm version is affected by several issues and limits that have led to the necessity of a new solution. Starting from the first stages of functional requirements (FRs) definition and decomposition (left side of the "V"), a new concept has been implemented, in order to be tested for its verification and validation (right side of the "V"). As part of the principles of SE, the process has been based on virtual models of the product and on virtual simulations of its operation, rather than on the realization of time-consuming and expensive physical models and tests, even if a final physical prototype has also been built and some physical operative tests have also been carried out on it. These tests have showed that the new product appears to fulfill each one of its FRs and overcome the limits imposed by the previous version. The future commissioning and operative tests in the real operating condition and location shall definitely validate the new product. [ABSTRACT FROM AUTHOR]