Search

300 M ultra-high-strength steel (UHSS) is widely used to produce landing gear components for aircraft. The conventional manufacturing route for these components involves extensive machining and significant material wastage. Here, the application of wire-based gas metal arc additive manufacturing to produce 300 M UHSS parts was investigated. In particular, the influence of torch shielding atmosphere on the process stability and material performance of 300 M UHSS was investigated. The shielding gases used for comparison are pure Ar, Ar with 2.5% CO2, Ar with 8% CO2, Ar with 20% CO2, and Ar with 2% CO2 and 38% He. It was found that the arc length decreased, the transfer mode changed from spray to droplet mode, and spattering became more severe as the CO2 proportion increased. Additionally, replacing Ar with He led to a broader arc core, and a slightly shorter arc length and maintained a spray transfer, which decreased spatter. The wall surface roughness followed the trend in spatter, becoming worse with the increasing CO2 proportion, and better with He addition. Adding CO2 and He in pure Ar significantly increased the bead and wall width. The microstructure and mechanical properties exhibited a strong location dependence in the as-built state, with fresh martensite and higher strength in the top region, and tempered martensite and better ductility in the reheated bulk. Generally, torch shielding gas composition appeared to have no significant effect on the microstructure evolution. This study provides a reference for the subsequent application of gas metal arc additive manufacturing to aircraft landing gear mass production to achieve a high deposition rate and process stability simultaneously. [ABSTRACT FROM AUTHOR]

In wire and arc additive manufacture (WAAM), the twist of wire during a robot's movement can result in the sudden changes of the wire-feeding position and thus cause deposition defects and dimensional errors. In the worst case, it may cause wire jamming and damage of the wire-feeding system. Therefore, online monitoring and correction of the wire deflection are very important for WAAM. In this paper, a vision-based measuring method is proposed for detecting the deviations of the wire-feeding position of a plasma welding-based WAAM process. It uses adaptive threshold and Hough transform to extract the wire edges, judges and merges the coincident lines, and applies Radon transform to measure the wire deflection. Software to automatically detect the wire deviation was developed based on the proposed method. The method and the software were verified with experiments. [ABSTRACT FROM AUTHOR]

In this study, the effect of arc mode in cold metal transfer (CMT) process on the porosity characteristic of additively manufactured Al-6.3%Cu alloy has been systematically investigated. The variants include conventional CMT, CMT pulse (CMT-P), CMT advanced (CMT-ADV) and CMT pulse advanced (CMT-PADV) and experiments were performed on both single layer deposits and multilayer deposits. The mechanism of porosity generation using the CMT arc mode variants is discussed. It was found that deposit porosity is significantly influenced by the arc mode type of CMT process. Conventional CMT is not suitable for the additive manufacturing process because it produces a large amount of gas pores, even in single layer deposit. CMT-PADV proved to be the most suitable process for depositing aluminium alloy due to its excellent performance in controlling porosity. With correct parameter, setting the gas pores can be eliminated. It was found that the key factors that enable the CMT-PADV process to control the porosity efficiently are the low heat input, a fine equiaxed grain structure and effective oxide cleaning of the wire. [ABSTRACT FROM AUTHOR]