Search

Abstract: The application of ground heat exchangers (GHEs) has attracted much attention for its advantages in terms of energy-saving and emission-reduction. Therefore, it is significant to introduce heat transfer into investigation, the paper illustrated the existing heat transfer models in order to analyze the GHEs with buried coils. Line heat source, cylindrical heat source and ring-coil heat source are introduced step by step. For the present, the borehole GHEs are the mainstream, and in recent years pile foundation GHEs have been followed with interest on account of heat transfer superiority as well as lowering initial cost and saving land area. Concerning that groundwater flow exist in geological stratum sometimes, so that the thermal analysis about heat transfer should be composed of two cases, i.e. models under the condition of both pure conduction and combination that include conduction and advection. It is obvious that ring-coil model is on the verge of actual situation for pile foundation GHEs with buried coils from the academic research perspectives, nevertheless for some engineering computation problems which the result error can be permitted in the certain range, other heat transfer models can be chosen in order to simplify the calculation process. [Copyright &y& Elsevier]

Abstract: The ground-coupled heat pump (GCHP) systems have been identified as one of the best sustainable energy technologies for space heating and cooling in buildings. While the foundation piles of buildings are used to partly take the place of boreholes in the ground heat exchanger (GHE) in recent years, the classical approaches of the line heat source model and the “hollow” cylindrical heat source model for the borehole GHEs fail for thermal analysis and design of the pile GHEs. Evolved from the classical models, a new “solid” cylindrical source model is presented in this paper to consider both the radial dimension and the heat capacity of the borehole or pile. Expressions of the analytical solution are derived for 1-D and 2-D new models by means of the Green’s function method. Results obtained from the new 1-D model are compared with the classical line source and “hollow” cylindrical source models of the borehole GHE, and also validated by a numerical solution of the same model. While the 1-D and 2-D solid cylindrical source models can provide adequate tools for design and simulation of the pile GHEs, improvement can also be achieved in simulating the temperature response of the borehole GHEs, especially for short time steps. [Copyright &y& Elsevier]