Search

Abstract: La0.3Sr0.7FeO3-δ (LSF)/CeO2 cathode supported Ce0.8Sm0.2O2-δ (SDC) electrolyte was prepared by a simple multilayer tape casting and co-firing method. SDC electrolyte slurry and LSF/CeO2 cathode slurry were optimized and the green bi-layer tapes were co-fired at different temperature. Phase characterizations and microstructures of electrolyte and cathode were studied by X-ray diffraction (XRD) and Scan Electronic Microscopy (SEM). No additional phase peak line was observed in electrolyte and cathode support when the sintering temperature lower was than 1400°C. The electrolytes were extremely dense with the thickness of about 20μm. The cathode support was porous with electrical conductivity of about 4.21S/cm at 750°C. With Ni/SDC as anode, Open Current Voltage and maximum power density reached 0.61V and 233mWcm−2 at 750°C, respectively. [Copyright &y& Elsevier]

As a cathode material for proton-conducting SOFCs (H–SOFCs), a novel MnCo 1.9 Sb 0.1 O 4 (MCSO) spinel material was suggested. The MCSO material was effectively produced, and it demonstrated excellent phase stability at elevated temperatures and chemical stability against CO 2 and H 2 O. Doping Sb into the MnCo 2 O 4 (MCO) allowed for enhanced proton diffusion and surface exchange, as evidenced by electrical conductivity relaxation tests. In addition, an oxygen-vacancy-rich surface was developed for the MCSO material, resulting in the possibility of a high cathode oxygen reduction reaction activity. The MCSO material was examined in the H–SOFC application, and the fuel cell with an MCSO cathode attained a high power density of 1380 mW cm−2 at 700 °C. At 700 °C, the cell employing the Sb-free MCO cathode, which had a comparable cell microstructure to the MCSO cell, only obtained a peak power density of 836 mW cm−2. The higher cell performance resulted from the Sb-modified MCO cathode's increased catalytic activity. In addition, the MCSO cell displayed excellent operational stability under fuel cell operating conditions, indicating that MCSO is a novel and effective spinel cathode for H–SOFCs. • A new MnCo 1.9 Sb 0.1 O 4 (MCSO) spinel was proposed for H–SOFCs. • Doping Sb into MnCo 2 O 4 (MCO) enhanced proton diffusion and surface exchange. • MCSO improved the cathode activity compared with Sb-free MCO. • A high performance was obtained for the fuel cell using MCSO cathode. [ABSTRACT FROM AUTHOR]

PrBaCo 2 O 5+δ (PBC) with high catalytic activity is identified as a prospective cathode material for intermediate temperature solid oxide fuel cells (IT-SOFCs). However, its poor chemical stability hinders its application. To address this problem, a Ta-doping strategy was presented in this study. The cathode with Ta-doping PBC was applied in proton conducting SOFCs. And the influence of Ta-doping on the crystal structure, electrochemical performance, structure stability and electrical conductivity of PBC was investigated. The resistance to CO 2 of PBC at elevated temperature is significantly improved with Ta-doping. The electrochemical performance measurements indicated that a low Ta-doping concentration did not change the performance of the cells obviously, while large Ta-doping concentration could lower the fuel cell performance. • Tantalum element was successfully doped into the crystal lattice of PBC. • Ta-doped PBC was successfully applied in H–SOFC. • The resistance to CO 2 of PBC at elevated temperature is significantly improved with Ta-doping. [ABSTRACT FROM AUTHOR]