Search

Abstract: In order to optimize operations of microbial electrolysis cell (MEC) for hydrogen production, microbial anode potential (MAP) was analyzed as a function of factors in biofilm anode system, including pH, substrate and applied voltage. The results in “H” shape reactor showed that MAP reflected the information when any factor became limiting for hydrogen production. Commonly, hydrogen generation started around anode potential of −250 mV to −300 mV. While, higher current density and higher hydrogen rate were obtained when MAP went down to −400 mV or even lower in this study. Biofilm anode could work normally between pH 6.5 and 7.0, while the lowest anode potential appeared around 6.8–7.0. However, when pH was lower 6.0 or substrate concentration was less than 50 mg L−1 in anode chamber, MAP went up to −300 mV or above, leading to hydrogen reduction. Applied voltage did not affect MAP much during the process of hydrogen production. Anode potential analysis also showed that planktonic bacteria in suspended solution presented positive effects on biofilm anode system and they contributed to enhance electron transfer by reducing internal resistance and lowering minimum voltage needed for hydrogen production to some extent. [ABSTRACT FROM AUTHOR]

As a reliable source for methane production, the major goal of our research was to design and testify a novel microbial electrolysis assisted upflow anaerobic (Upflow-MEC) reactor for beer wastewater treatment and simultaneous methane production. Three reactors with different cathode materials were constructed and the reactor with Ni cathode had a maximum COD removal of 85%, methane yield of 142.8 mL/gCOD, TOC removal of 83%, Carbohydrate removal of 97%, Protein removal of 62% and current production of 8.6 mA, under 0.8 V applied voltage at HRT of 24 h. It was an application-oriented, membrane-free, continuous reactor and shortening the reaction time and increasing organic content conversion to methane were the key developing targets. [ABSTRACT FROM AUTHOR]

The effects of chemosynthetic and biological surfactants on accelerating hydrogen generation from waste activated sludge (WAS) is investigated in a short-cut fermentation-bioelectrochemical system. The specific experiments are conducted in a series of completely stirred tank reactors (CSTRs) and single-chamber microbial electrolysis cells (MECs). Results shows that rhamnolipid (RL) lead to a VFAs yield 1.16-fold and 3.63-fold higher over with sodium dodecylsulphate (SDS) and sodium dodecyl benzene sulfonate (SDBS) treatments in CSTRs on 72 h. By contrast, the corresponding conversion efficiency of methanogenesis is inhibited (0.18 ± 0.03% versus 1.89 ± 0.15% (SDS) and 6.63 ± 0.77% (SDBS)), which is beneficial for subsequent hydrogen production in MECs. The distribution of the acidogenesis metabolites is also affected by the types of surfactants, reflected on cascade changing of hydrogen production. Highest hydrogen yield is 12.90 mg H 2 g −1 VSS in RL-MECs, which is larger than all values that have been reported for fermentation and single-chamber MECs. Current and electrochemical impedance spectroscopy clearly demonstrate the important role of RL treatment in electron/proton transfer and the internal resistance decrease. This study demonstrate the sustainability and attractiveness of WAS short-cut fermentation-elelctrohydrogenesis, providing a sound basis for sludge stabilization and bioenergy recovery. [ABSTRACT FROM AUTHOR]