Search

The effect of Al content on the microstructure, damping behavior and mechanical properties of Mg-xAl-0.5Ce (wt%) damping alloys was systematically studied. Al content had a great effect on the morphology features of Al 4 Ce phases. The quasi-rectangular network structure was observed in as-cast Mg-1Al-0.5Ce alloy. The Al addition promoted the dynamic recrystallization during extrusion process and led to the texture weakening, but the basal texture was sharpened with further Al addition due to the consumption of the Ce solute. The as-extruded Mg-1Al-0.5Ce alloy showed the best damping capacity among as-extruded Mg-xAl-0.5Ce alloys, which was mainly ascribed to the texture weakening. The ductility was improved with increasing Al content, while the strength was reduced. This behavior was related with the texture weakening and increasing grain sizes. The as-extruded Mg-1Al-0.5Ce alloy exhibited the excellent comprehensive performance. The peak P 2 of as-extruded alloys in the first heating run was a superimposed peak, consisting of a grain boundary relaxation peak and a recrystallization peak. The grain boundary peaks P 2 in the second heating run shifted to lower temperatures and their activation energies decreased with increasing Al content. The reasons for the variation of the grain boundary peak P 2 were discussed. [ABSTRACT FROM AUTHOR]

Developing magnesium (Mg) alloys with both high elastic modulus and damping capacity is a long-term challenge in the field of lightweight metals. Herein, it is shown that alloying with Si in Mg-Gd-Y-Zn-Mn simultaneously increased the elastic modulus and damping capacity. After Si alloying, the LPSO phase was greatly reduced and a large number of (RE + Si)-rich particles were formed. Due to the contribution of the high modulus second phases, the elastic modulus of the extruded Mg-Gd-Y-Zn-Mn alloy with a trace amount of Si was 49.3 GPa, 8 GPa greater than that of the extruded pure Mg. In addition, the extruded Mg-Gd-Y-Zn-Mn-Si alloy possessed good damping capacity at both room temperature (RT) and high temperature. At high strain amplitude, the extruded Mg-Gd-Y-Zn-Mn-Si alloy achieved a RT damping value of Q −1 > 0.01, significantly higher than the extruded pure Mg, which was related to the high density of thermal mismatch dislocations in the vicinity of the interfaces between the reinforcing phase and the α-Mg matrix. With the increasing temperature, the extruded Mg-Gd-Y-Zn-Mn-Si alloy showed obviously higher damping capacity than the extruded Si-free alloy, which was attributed to the incoherent phase interfaces, weakened texture and thermal mismatch dislocations. • Elastic modulus and damping capacity of a Mg alloy were improved simultaneously. • High Young's modulus (RE + Si)-rich particles were produced due to Si addition. • Good damping capacity at both room temperature and high temperature were obtained. [ABSTRACT FROM AUTHOR]