Search

Hip fractures are the most serious complication of osteoporosis and have been recognized as a major public health problem. In elderly persons, hip fractures occur as a result of increased fragility of the proximal femur due to osteoporosis. It is essential to precisely quantify the strength of the proximal femur in order to estimate the fracture risk and plan preventive interventions. CT-based finite element analysis could possibly achieve precise assessment of the strength of the proximal femur. The purpose of this study was to create a simulation model that could accurately predict the strength and surface strains of the proximal femur using a CT-based finite element method and to verify the accuracy of our model by load testing using fresh frozen cadaver specimens. Eleven right femora were collected. The axial CT scans of the proximal femora were obtained with a calibration phantom, from which the 3D finite element models were constructed. Materially nonlinear finite element analyses were performed. The yield and fracture loads were calculated, while the sites where elements failed and the distributions of the principal strains were determined. The strain gauges were attached to the proximal femoral surfaces. A quasi-static compression test of each femur was conducted. The yield loads, fracture loads and principal strains of the prediction significantly correlated with those measured (r=0.941, 0.979, 0.963). Finite element analysis showed that the solid elements and shell elements in undergoing compressive failure were at the same subcapital region as the experimental fracture site.

A technique was developed to create a reproducible femoral neck fracture in vitro using 5-month-old JW/CSK series male rabbits. Force attenuation of a newly developed damping material was also evaluated using this model. Ten pairs of the femora with smaller deviations in length and weight were harvested and cleaned of soft tissue. Either a right or left of each pair of the specimens was randomly selected and put into either the control or the experimental group, both of which contained equal numbers of the right and left femora. The specimens were attached to an L-shaped plate and embedded in a resin from the proximal diaphysis to the distal end so as to maintain a consistent position of the femora. They were mounted and fixed on a pedestal slanted in the coronal plane at 20 degrees. The impact load testing was conducted using an impact mallet dropped from a height of 3 cm. The impact load was applied onto the femoral head. To the specimens in the experimental group, attenuated impact forces were loaded through the damping material, but those in the control group were subjected to forces directly transmitted without the material. All the impact testing was performed in a temperature and humidity controlled chamber. All of the femoral specimens exposed to the direct impact forces (controlled group) sustained fracture at the neck. The fracture line passed from the base of the femoral head laterally and to the calcar area just proximal to the minor trochanter medially. The location of each fracture line was almost identical among the specimens. None of the specimens that were exposed to the impact force through the damping material (experimental group) sustained fracture macroscopically and roentgenographically.