Search

This study aimed to characterize the anatomical and physiological features of pits and fissures in primary and permanent molars by microtomographic (micro-CT) examination and three-dimensional (3D) printing. The occlusal surfaces of 84 primary molars and 60 permanent third molars were examined. The samples were scanned with micro-CT and the occlusal surface separated. The areas of the crown, its occlusal part, and fissures and pits were calculated. Digital impression of the occlusal surface was created and 3D printed. The frequency of different fissure types was determined by direct observation. Data were subjected to statistical analysis using Mann-Whitney U Test and chi-square test ( p < 0.05). There was statistically significant difference between the ratio of occlusal surface and the crown area for the molars in primary and permanent dentitions (24.78% and 28.85% respectively, p < 0.05). In terms of the percentage ratio of the fissure area to the occlusal surface (24.24% and 22.30%) and the fissure area to the crown (6.02% and 6.52%), no significant difference was observed ( p > 0.05). V-shaped fissures were predominant in both primary and permanent teeth, with a higher occurrence in primary dentition (59.48%, p < 0.05). Permanent molars exhibited a higher prevalence of I-type and U-type fissure configurations compared to primary molars ( p < 0.05), with I-type fissures being the least common in primary molars. In both dentitions there was no statistically significant difference in the prevalence of IK-configuration ( p > 0.05). The fissure depth was significantly greater in permanent molars than primary molars ( p < 0.05). In conclusion, this study revealed remarkable diversity in fissure morphology among primary and permanent molars., Competing Interests: The authors declare no conflict of interest., (©2024 The Author(s). Published by MRE Press.)

Objective-The aim of this study was to assess the effect of magnification and air-drying on detection of carious lesion. Study Design-44 human extracted premolars were selected with sound occlusal surfaces without frank cavitation. The Diagnostic techniques used were Unaided visual examination, Magnifying Loupes (4.2×) and Stereomicroscope (10×, before and after air-drying) and then the teeth were sectioned bucco-lingually and both the surfaces were examined under Stereomicroscope (50×) to assess the presence or absence of carious lesion in the pit and fissures. The scores were compared to obtain Cohen's kappa coefficient (Reproducibility) and subjected to the Friedman Test and Paired t test. Sensitivity, specificity and positive predictive value used to assess accuracy. Results-On Statistical analysis, visual examination before and after air drying had highest specificity but lowest sensitivity compared to different diagnostic techniques. Magnifying loupes after air-drying had highest sensitivity and lowest specificity compared to other diagnostic techniques. Conclusion-Air drying combined with magnifying aids are cost-effective, reliable method for detection of early carious lesion. If used in pediatric clinical practice, any undesirable pain and discomfort to the patient due to invasive procedures and helps in employing preventive measures.

This study aimed to validate clinical analysis of 20 pediatric dentists on occlusal groove-fossa-system of molar depth comparing to Cone-beam tomography. The 48 sound third molars were visually classified from the shallowest to the deepest. Images were taken from the Accuitomo 3DX. There was a fair correlation between clinical analysis and the tomographic scorings (rs = 0.238; P = 0.103). It was concluded that pediatric dentists were not able to classify the fissures depth by visual analysis correctly.