Search

Block-flexure toppling failure is frequently encountered in interbedded anti-inclined rock (IAR) slopes, and seriously threatens the construction of hydropower infrastructure. In this study, we first investigated the Lean Reservoir area's geological setting and the Linda landslide's characteristics. Then, uniform design and random design were used to design 110 training datasets and 31 testing datasets, respectively. Afterwards, the toppling response was obtained by using the discrete element code. Finally, support vector regression was used to obtain the influence weights of 21 impact factors. The results show that the influence weight of the slope angle and rock formation dip angle on the toppling deformation among tertiary impact factors is 25.96% and 17.28%, respectively, which are much greater than the other 19 impact factors within the research range. For the primary impact factors, the influence weight is sorted from large to small as slope geometry parameters, joints parameters, and rock mechanics parameters. Joints parameters, especially the geometric parameters, cannot be ignored when evaluating the stability of IAR slopes. Through numerical simulation, it was qualitatively determined that failure surfaces of slopes were controlled by cross joints and that the rocks in the slope toe play a role in preventing slope deformation. [ABSTRACT FROM AUTHOR]

A simplified geomechanical model was proposed by considering three typical necking-type slopes; this model lays a foundation for the further investigation of the deformation behaviors of such slopes. Three physical models of necking-type slopes were built according to the geomechanical model with slope evolution stages. Finally, preliminary calculations related to the arching effect in the physical model were conducted. Three evolution stages of necking-type slopes, namely, the initial stage, compression stage, and failure stage, were presented based on the formation and disappearance of the arching effect within the slope. The specific parameters of the geomechanical model were given. In the setup of the tilting test, the failure angle of the necking-type slope model was calculated to be approximately 50° with a large lateral resistance coefficient. The proposed geomechanical model and physical models of necking-type slopes provide guidance for the establishment of geomechanical and physical models of landslides at specific sites. [ABSTRACT FROM AUTHOR]