Search

We investigated the effects of the propagation path and site amplification of shallow tremors along the Nankai Trough. Using far‐field S‐wave propagation from intraslab earthquake data, the amplification factors at the DONET stations were 5–40 times against an inland outcrop rock site. Thick (∼5 km) sedimentary layers with VS of 0.6–2 km/s beneath DONET stations have been confirmed by seismological studies. To investigate the effects of thick sedimentary layers, we synthesized seismograms of shallow tremors and intraslab earthquakes at seafloor stations. The ratios of the maximum amplitudes from the synthetic intraslab seismograms between models with and without thick sedimentary layers were 1–2. This means that thin lower‐velocity (<0.6 km/s) sediments just below the stations primarily control the estimated large amplifications. Conversely, at near‐source (≤20 km) distances, 1‐order amplifications of seismic energies for a shallow tremor source can occur due to thick sedimentary layers. Multiple S‐wave reflections between the seafloor and plate interface are contaminated in tremor envelopes; consequently, seismic energy and duration are overestimated. If a shallow tremor occurs within underthrust sediments, the overestimation becomes stronger because of the invalid rigidity assumptions around the source region. After 1‐order corrections of seismic energies of shallow tremors along the Nankai Trough, the scaled energies of seismic slow earthquakes were 10−10–10−9 irrespective of the region and source depth. Hence, the physical mechanisms governing seismic slow earthquakes can be the same, irrespective of the region and source depth. Plain Language Summary: The deployment of campaigns and permanent ocean bottom seismometers (OBSs) has enabled us to investigate the activity and physical properties of offshore seismic phenomena. Our knowledge of offshore subsurface structures is still limited; consequently, many studies have used conventional analysis methods with the simplest assumptions. Using observed and synthetic seismograms near the Nankai Trough, we found a limitation in the conventional analysis method applied to OBS data. Thick sedimentary layers, which have been confirmed by seismological studies along the Nankai Trough just below the OBSs, cause an approximately 1‐order overestimation of source parameters for seismic phenomena occurring around the shallow plate boundary. This overestimation may have occurred during the seismic energy estimation of shallow slow earthquakes in Hikurangi, Costa Rica, and Mexico. After correcting for the effects of thick sedimentary layers, we found that the scaled energies of seismic slow earthquakes were 10−10–10−9 irrespective of the region and source depth. This suggests that the physical mechanisms governing seismic slow earthquakes can be the same, regardless of region and source depth. Key Points: Effects of path and site on the seismic energy estimation of slow earthquakes at shallow plate boundaries were investigatedThe assumption of far‐field body waves without thick sediments causes an overestimation of seismic energies for shallow tremorsScaled energies of seismic slow earthquakes at both shallow and large depths range from 10−10 to 10−9 [ABSTRACT FROM AUTHOR]

Fluid migration in subduction zones is a key controlling factor of slow and megathrust earthquakes at plate boundaries. During the migration, seismic velocity and heterogeneous structures in its pathways may be temporarily perturbed, preferably triggering slow earthquakes. Here, we show that transient changes of seismic heterogeneity occurred 0–9 months before shallow slow earthquakes in the Nankai subduction zone, Japan, using very long‐term (6–10 years) records of ambient seafloor noise. The heterogeneity changes preceding to shallow slow earthquakes were observed near the margin of the source region, while concurrent changes primarily occurred in the source region. We propose that the heterogeneity changes are attributed to dynamic fluid migration, and the difference in timings reflects the pore pressure level in the corresponding source region. When fluids are supplied to a source region under relatively low pressure, fluids are leaked out from its downdip or updip side, and slow earthquakes occur not immediately but with a time delay of at most 9 months. In the high pore pressure case, slow earthquakes occur immediately with fluid migration from the source region. This study suggests that the heterogeneous seismic structure is possibly changed by fluid migration before slow earthquakes in the Nankai subduction zone. Plain Language Summary: While the linkage between fluid and slow earthquakes occurring at the plate boundary of subduction zones has been revealed, such a relationship for very shallow parts close to trench axes remains elusive. In this study, we investigated the temporal variations of seismic velocity and heterogeneous structure beneath the seafloor in the Nankai subduction zone, Japan, using the seismographs observed by a permanent cabled network starting in 2010. The intensities of seismic heterogeneous structures change 0–9 months prior to the shallow slow earthquakes, implying that the heterogeneous structure is altered by fluid migration that affects the slow earthquake generation. In the case of the fluid migration preceding to slow earthquakes, fluids are supplied to the source region with relatively low pore pressure levels, and the pore pressure level there increases until the timing of the slow earthquake generation. In contrast, the case of concurrent fluid migration corresponds to the fluids supplied to the source region with a relatively high pore pressure level, and slow earthquakes occur at the immediate timing of the fluid supply. These results suggest that monitoring heterogeneous seismic structures potentially contributes to further understanding of the spatio‐temporal relationship between fluid migration and shallow slow earthquakes. Key Points: Transient changes of seismic heterogeneities occurred 0–9 months before slow earthquakes in the shallow Nankai subduction zoneWe consider that the heterogeneity changes are caused by fluid migrationThe difference in timings between fluid migration and slow earthquakes reflects the pore pressure levels at the source regions [ABSTRACT FROM AUTHOR]

Deep and shallow slow earthquakes occur at the edge of the seismogenic zone in the Nankai subduction zone. Deep slow earthquakes occur under high‐temperature and high‐pressure conditions, whereas shallow slow earthquakes occur at lower temperatures and pressures. Although these two types of slow earthquake show qualitatively similar behaviors, such as slow deformation and depleted high‐frequency seismic signals, their similarities have not yet been evaluated in quantitative ways. In this work, we analyze shallow tectonic tremors accompanied by very low frequency earthquakes off Kii Peninsula, Japan. We estimate the seismic energy of the shallow tectonic tremors by correcting for the site amplifications of ocean bottom seismic stations and seismic attenuation in the shallow accretionary prism. The estimated seismic energy rates of these tectonic tremors are compared with seismic moment rates of accompanying very low frequency earthquakes, revealing that the scaled energy of shallow slow earthquakes is roughly constant, ~10−9 to 10−8, which is 0 to 1 order of magnitude larger than the typical scaled energy of deep slow earthquakes. Key Points: Seismic energy of shallow tectonic tremor is quantified correcting for site amplification and seismic attenuationSeismic energy rates and seismic moment rates of shallow tremors show along‐dip variations, which are similar to deep tremorsThe scaled energy of shallow slow earthquake is 0 to 1 order of magnitude larger than deep slow earthquake [ABSTRACT FROM AUTHOR]