Search

In this paper, the effect of Al 3+ substitution on the electrical and dielectric properties of Ni 0.25 Cu 0.20 Zn 0.55 Al x Fe 2-x O 4 ferrites with x = 0.0, 0.05. 0.10, 0.15 and 0.20, synthesized by solid state reaction has been reported. Using two probe method, the DC resistivity has been investigated in the temperature range from 30 °C to 300 °C. Activation energy was calculated from the Arrhenius plot. The electrical conduction is explained on the basis of the hopping mechanism. The frequency dependent dielectric properties of these spinel ferrites have been studied at room temperature by measuring AC resistivity, conductivity ( σ ac ), dielectric constant and dielectric loss tangent (tan δ ) in the frequency range between 1 kHz and 120 MHz. The study of dielectric properties showed that the dielectric constant and dielectric loss increased with increasing non-magnetic Al ions. The dependence of dielectric constant with frequency has been explained by Maxwell-Wagner interfacial polarization. Cole-Cole plots show semicircular arc(s) for the samples, and equivalent RC circuits have been proposed to clarify the phenomena involved therein. The analysis of complex impedance spectroscopy has been used to distinguish between the grain and grain boundary contribution to the total resistance. [ABSTRACT FROM AUTHOR]

Abstract: The influence of different heat treatments on the magnetic and magnetoelastic properties of highly magnetostrictive CoFe2O4 has been investigated. The first order cubic anisotropy coefficient, coercive field, magnetostriction and high strain sensitivity were observed to decrease as the heat treatment temperature increased. The saturation magnetization of the samples on the other hand increased with increase in heat treatment temperature. These changes were not accompanied by any observable changes in crystal structure or composition and are indicative of migration of Co2+ from the octahedral sites (B-sites) to the tetrahedral sites (A-sites) and Fe3+ from the A-sites to the B-sites of the spinel structure. Different distributions of the cations at the two distinct lattice sites can strongly affect the magnetic and magnetoelastic properties of these materials. [Copyright &y& Elsevier]

Abstract: Differences in the microstructure and magnetic properties of highly magnetostrictive cobalt ferrite resulting from the effects of different vacuum sintering temperatures and times have been investigated. A vacuum environment was chosen to allow direct comparison of results with air-sintered samples which are more often reported in the literature. It was found that vacuum sintering resulted in the development of a solid solution second phase with composition Co1− x Fe x O4 (x∼0.33). There was a decrease in magnetostriction as a result of the formation of the second phase. Furthermore, differences in sintering temperatures were found to have a greater effect on the magnetostriction than differences in sintering times. It was found that the first order cubic anisotropy coefficient initially increased with both sintering temperature and time, before peaking and decreasing to its lowest measured value. The lowest anisotropy was therefore achieved with samples sintered at higher temperatures and longer times. [Copyright &y& Elsevier]

Abstract: Nanocomposite of hard (BaFe12O19) and soft ferrite (Ni0.8Zn0.2Fe2O4) are prepared by the mixing of the individual ferrite components at appropriate ratio and subsequent heat treatment. Initially the microstructure of the individual phases is controlled by suitable processing. We have observed the exchange spring behavior in the soft–hard ferrite composite for the first time by tailoring the particle size of the individual phases and by suitable thermal treatment of the composite. It is found that the exchange interaction dominates over the dipolar interaction for smaller particle sizes of the soft ferrite. The magnetization of the composite showed hysteresis loop that is characteristic of the exchange spring system. This gives experimental proof for some theoretical modeling as well as paves way for developing magnet with higher (BH)max product based on ferrites. [Copyright &y& Elsevier]