Search

The partial dissipation of Gibbs energy as heat reflects the metabolic dynamic of biofilms in real time and may also allow quantitative conclusions about the chemical composition of the biofilm via Hess' law. Presently, the potential information content of heat is hardly exploited due to the low flexibility, the low throughput and the high price of conventional calorimeters. In order to overcome the limitations of conventional calorimetry a miniaturized calorimeter for biofilm investigations has been evaluated. Using four thermopiles a heat production with spatial and temporal resolutions of 2.5 cm(-1) and 2 s(-1) could be determined. The limit of detection of the heat flow measurement was 20 nW, which corresponds to the cell density of an early stage biofilm (approx. 3x10(5) cells cm(-2)). By separating biofilm cultivation from the actual heat measurement, a high flexibility and a much higher throughput was achieved if compared with conventional calorimeters. The approach suggested allows cultivation of biofilms in places of interest such as technological settings as well as in nature followed by highly efficient measurements in the laboratory. Functionality of the miniaturized calorimeter was supported by parallel measurements with confocal laser scanning microscopy and a fiber optic based oxygen sensor using the oxycaloric equivalent (-460 kJ mol-O2(-1)).

A simple microscopic method to three-dimensionally differentiate between various members in photo-autotrophic biofilm systems is described. By dual-channel single-photon (confocal) and two-photon laser scanning microscopy, the signals in the red and far red channels as well as their combination can be simultaneously recorded. The method takes advantage of the autofluorescent signal of cyanobacteria-recorded in the red and far red channel and the autofluorescent signal of the green algae-recorded in the far red channel only. The differentiation is based on the specific pigment composition of cyanobacteria and green algae in combination with the appropriate filter settings for detection of the autofluorescent emission signals. The method allows the non-destructive, three-dimensional examination of fully hydrated interfacial microbial communities at high resolution as well as the clear separation between autofluorescent signals of cyanobacteria and green algae. Furthermore, there is a third option to record additional signals simultaneously such as nucleic acid stained bacteria, bacteria labeled with phylogenetic probes or glycoconjugates stained by using lectins. With state of the art laser scanning microscopes, even a fourth channel is available for recording yet another parameter, e.g. in the reflection (single-photon only) or fluorescence (single- and two-photon) mode. Thus the approach represents a convenient tool to study multiple parameters of complex photo-autotrophic biofilm systems.

The performance of two types of rotating annular reactors for the cultivation of river biofilms was compared qualitatively and quantitatively. One reactor was a commercially available system with a rotating inner solid cylinder and polycarbonate slides in the outer fixed cylinder. The other, a non-commercial system manufactured in the laboratory, had the polycarbonate slides positioned on a machined, rotating inner cylinder. Microscale comparison of the biofilms was carried out using confocal laser scanning microscopy techniques including, fluorescent nucleic acid staining, fluor conjugated lectins and autofluorescence imaging. The results obtained indicated that the reactors were similar in terms of biofilm development pattern, thickness, bacterial biomass, and exopolymer production. Significant differences were found in terms of photosynthetic biomass with the glass bodied non-commercial reactor providing more favourable conditions for algal growth than the opaque polycarbonate outer cylinder of the commercial reactor. The study indicated that a simple inexpensive reactor constructed from available components and materials, produced river biofilms similar to those obtained using a commercial system but at substantially lower cost. The availability of such inexpensive annular reactors should facilitate much needed replicated studies of biofilm development.

Techniques are required for the simultaneous or sequential determination of multiple parameters within microbial biofilms. Confocal scanning laser microscopy in combination with a range of fluorescent probes and markers offers an approach to quantitatively defining many aspects of biofilm communities. By applying multispectral imaging in conjunction with nucleic acid stains, fluor conjugated lectins, and autofluorescence we have developed a simple approach to evaluate biofilm community composition. Biofilms were treated with the fluorescent nucleic acid stain SYTO 9 to allow quantification of bacterial biomass and fluor conjugated lectins (i.e., Triticum vulgaris lectin) to identify and allow quantification of exopolymeric substances. Far red autofluorescence was imaged to quantify algal biomass. Digital image analysis of the CSLM optical thin sections in each of the channels was used to determine such parameters as biofilm depth, bacterial cell area (biomass), exopolymer area and algal biomass at various depths and locations. In addition, three colour red–green–blue projections of the biofilms were computed. The method proved simple and effective for determining treatment effects such as grazing by invertebrates.

With the increasing complexity of model systems for the investigation of antibacterial effects of nanoparticles, the demands on appropriate analysis methods are rising. In case of biofilms grown on small particles, the high inhomogeneity of the samples represents a major challenge for traditional biofilm analysis. For this purpose, we developed a new calorimetric method which allows non-invasive and real-time investigation of the effects of nanoparticles on beads-grown biofilms which meets the requirements for an increased sample throughput. The method employs a newly developed chip calorimeter that is able to detect changes in the metabolic activity of biofilm samples within minutes. Using this novel device, the antibacterial effect of silver nanoparticles on Pseudomonas putida biofilms grown on agarose beads was investigated. The superparamagnetic properties of the embedded particles within the agarose beads allow an automated sample throughput. Growth inhibition and inactivation effects of silver nanoparticles (AgNPs) on biofilm bacteria were quantified by analyzing the metabolic heat production rate. As a result, a concentration dependent manner of growth inhibition and inactivation was found demonstrating the suitability and sensitivity of the methodology.

Modified protocols of fluorescence in situ hybridization (FISH) and catalyze reporter deposition fluorescence in situ hybridization (CARD-FISH) were developed in order to detect bacteria in situ in calcified stromatolite biofilms. Smooth, well-preserved thin sections of calcified biofilms (approximately 5 microm thin, vertical sectioning of approximately 1 cm deep) were obtained by cryo-sectioning using the adhesive tape-stabilization technique. A modified hybridization buffer was applied during hybridization to prevent calcite dissolution as well as false binding of oligonucleotide probes to the charged mineral surfaces. Particularly, bright and specific CARD-FISH signals allowed the detection of bacteria in intensively calcified biofilms even at low magnification, which is suitable for investigating millimeter- to centimeter-scale vertical distribution patterns of bacteria.

A technique combining fluorescent in situ hybridization and lectin-binding-analysis (FISH-LBA) was developed and applied for the simultaneous detection of cellular components and glycoconjugates in lotic microbial aggregates (river snow). River snow aggregates were directly collected from the bulk water phase into coverslip chambers, in which the complete procedure including fixation, fluorescent in situ hybridization, lectin-binding and optical analysis by confocal laser scanning microscopy was performed. Neither autofluorescence originating from phyotosynthetic organisms nor inorganic particles did negatively interfere with the FISH-LBA technique. In river snow samples obtained from the river Elbe, Germany, distinct compartments of the river snow structure could be visualized with FITC-labelled lectins from Triticum vulgaris, Limulus polyphemus, Arachis hypogaea, Phaseolus vulgaris and Pseudomonas aeruginosa, binding to frequently occurring saccharide residues in the river snow matrix. The analysis could be performed on different levels of complexity. The combined technique visualized bacteria of different phylogenetic groups in the entire river snow structure as well as glycoconjugate components linked with various microcolonies. Different lectins stained slime layers and cell-envelopes of individual eukaryotic and prokaryotic cells. Consequently, application of the FISH-LBA technique allows the linkage between cellular and glycoconjugate identity in complex microbial communities.