Search

Abstract Background Falls due to stumbling are prevalent for transfemoral prosthesis users and may lead to increased injury risk. This preliminary case series analyzes the transfemoral prosthesis user stumble recovery response to highlight key deficits in current commercially-available prostheses and proposes potential interventions to improve recovery outcomes. Methods Six transfemoral prosthesis users were perturbed on their prosthetic limb at least three times while walking on a treadmill using obstacle perturbations in early, mid and late swing. Kinematic data were collected to characterize the response, while fall rate and key kinematic recovery metrics were used to assess the quality of recovery and highlight functional deficits in current commercially-available prostheses. Results Across all participants, 13 (54%) of the 24 trials resulted in a fall (defined as > 50% body-weight support) with all but one participant (83%) falling at least once and two participants (33%) falling every time. In contrast, in a previous study of seven young, unimpaired, non-prosthesis users using the same experimental apparatus, no falls occurred across 190 trials. For the transfemoral prosthesis users, early swing had the highest rate of falling at 64%, followed by mid-swing at 57%, and then late swing at 33%. The trend in falls was mirrored by the kinematic recovery metrics (peak trunk angle, peak trunk angular velocity, forward reach of the perturbed limb, and knee angle at ground contact). In early swing all four metrics were deficient compared to non-prosthesis user controls. In mid swing, all but trunk angular velocity were deficient. In late swing only forward reach was deficient. Conclusion Based on the stumble recovery responses, four potential deficiencies were identified in the response of the knee prostheses: (1) insufficient resistance to stance knee flexion upon ground contact; (2) insufficient swing extension after a perturbation; (3) difficulty initiating swing flexion following a perturbation; and (4) excessive impedance against swing flexion in early swing preventing the potential utilization of the elevating strategy. Each of these issues can potentially be addressed by mechanical or mechatronic changes to prosthetic design to improve quality of recovery and reduce the likelihood a fall.

Abstract Background Passive-dynamic ankle–foot orthoses (PD-AFOs) are often prescribed to address plantar flexor weakness during gait, which is commonly observed after stroke. However, limited evidence is available to inform the prescription guidelines of PD-AFO bending stiffness. This study assessed the extent to which PD-AFOs customized to match an individual’s level of plantar flexor weakness influence walking function, as compared to No AFO and their standard of care (SOC) AFO. Methods Mechanical cost-of-transport, self-selected walking speed, and key biomechanical variables were measured while individuals greater than six months post-stroke walked with No AFO, with their SOC AFO, and with a stiffness-customized PD-AFO. Outcomes were compared across these conditions using a repeated measures ANOVA or Friedman test (depending on normality) for group-level analysis and simulation modeling analysis for individual-level analysis. Results Twenty participants completed study activities. Mechanical cost-of-transport and self-selected walking speed improved with the stiffness-customized PD-AFOs compared to No AFO and SOC AFO. However, this did not result in a consistent improvement in other biomechanical variables toward typical values. In line with the heterogeneous nature of the post-stroke population, the response to the PD-AFO was highly variable. Conclusions Stiffness-customized PD-AFOs can improve the mechanical cost-of-transport and self-selected walking speed in many individuals post-stroke, as compared to No AFO and participants’ standard of care AFO. This work provides initial efficacy data for stiffness-customized PD-AFOs in individuals post-stroke and lays the foundation for future studies to enable consistently effective prescription of PD-AFOs for patients post-stroke in clinical practice. Trial Registration: NCT04619043.

Abstract Background Optic flow—the apparent visual motion experienced while moving—is absent during treadmill walking. With virtual reality (VR), optic flow can be controlled to mediate alterations in human walking. The aim of this study was to investigate (1) the effects of fully immersive VR and optic flow speed manipulation on gait biomechanics, simulator sickness, and enjoyment in people post-stroke and healthy people, and (2) the effects of the level of immersion on optic flow speed and sense of presence. Methods Sixteen people post-stroke and 16 healthy controls performed two VR-enhanced treadmill walking sessions: the semi-immersive GRAIL session and fully immersive head-mounted display (HMD) session. Both consisted of five walking trials. After two habituation trials (without and with VR), participants walked three more trials under the following conditions: matched, slow, and fast optic flow. Primary outcome measures were spatiotemporal parameters and lower limb kinematics. Secondary outcomes (simulator sickness, enjoyment, and sense of presence) were assessed with the Simulator Sickness Questionnaire, Visual Analogue Scales, and Igroup Presence Questionnaire. Results When walking with the immersive HMD, the stroke group walked with a significantly slower cadence (-3.69strides/min, p = 0.006), longer stride time (+ 0.10 s, p = 0.017) and stance time for the unaffected leg (+ 1.47%, p = 0.001) and reduced swing time for the unaffected leg (− 1.47%, p = 0.001). Both groups responded to the optic flow speed manipulation such that people accelerated with a slow optic flow and decelerated with a fast optic flow. Compared to the semi-immersive GRAIL session, manipulating the optic flow speed with the fully immersive HMD had a greater effect on gait biomechanics whilst also eliciting a higher sense of presence. Conclusion Adding fully immersive VR while walking on a self-paced treadmill led to a more cautious gait pattern in people post-stroke. However, walking with the HMD was well tolerated and enjoyable. People post-stroke altered their gait parameters when optic flow speed was manipulated and showed greater alterations with the fully-immersive HMD. Further work is needed to determine the most effective type of optic flow speed manipulation as well as which other principles need to be implemented to positively influence the gait pattern of people post-stroke. Trial registration number: The study was pre-registered at ClinicalTrials.gov (NCT04521829).

Abstract Background Individualized, targeted, and intense training is the hallmark of successful gait rehabilitation in people post-stroke. Specifically, increasing use of the impaired ankle to increase propulsion during the stance phase of gait has been linked to higher walking speeds and symmetry. Conventional progressive resistance training is one method used for individualized and intense rehabilitation, but often fails to target paretic ankle plantarflexion during walking. Wearable assistive robots have successfully assisted ankle-specific mechanisms to increase paretic propulsion in people post-stroke, suggesting their potential to provide targeted resistance to increase propulsion, but this application remains underexamined in this population. This work investigates the effects of targeted stance-phase plantarflexion resistance training with a soft ankle exosuit on propulsion mechanics in people post-stroke. Methods We conducted this study in nine individuals with chronic stroke and tested the effects of three resistive force magnitudes on peak paretic propulsion, ankle torque, and ankle power while participants walked on a treadmill at their comfortable walking speeds. For each force magnitude, participants walked for 1 min while the exosuit was inactive, 2 min with active resistance, and 1 min with the exosuit inactive, in sequence. We evaluated changes in gait biomechanics during the active resistance and post-resistance sections relative to the initial inactive section. Results Walking with active resistance increased paretic propulsion by more than the minimal detectable change of 0.8 %body weight at all tested force magnitudes, with an average increase of 1.29 ± 0.37 %body weight at the highest force magnitude. This improvement corresponded to changes of 0.13 ± 0.03 N m kg− 1 in peak biological ankle torque and 0.26 ± 0.04 W kg− 1 in peak biological ankle power. Upon removal of resistance, propulsion changes persisted for 30 seconds with an improvement of 1.49 ± 0.58 %body weight after the highest resistance level and without compensatory involvement of the unresisted joints or limb. Conclusions Targeted exosuit-applied functional resistance of paretic ankle plantarflexors can elicit the latent propulsion reserve in people post-stroke. After-effects observed in propulsion highlight the potential for learning and restoration of propulsion mechanics. Thus, this exosuit-based resistive approach may offer new opportunities for individualized and progressive gait rehabilitation.

Abstract Background Ankle-targeting resistance training for improving plantarflexion function during walking increases rehabilitation intensity, an important factor for motor recovery after stroke. However, understanding of the effects of resisting plantarflexion during stance on joint kinetics and muscle activity—key outcomes in evaluating its potential value in rehabilitation—remains limited. This initial study uses a unilateral exosuit that resists plantarflexion during mid-late stance in unimpaired individuals to test the hypotheses that when plantarflexion is resisted, individuals would (1) increase plantarflexor ankle torque and muscle activity locally at the resisted ipsilateral ankle, but (2) at higher forces, exhibit a generalized response that also uses the unresisted joints and limb. Further, we expected (3) short-term retention into gait immediately after removal of resistance. Methods Ten healthy young adults walked at 1.25 m s−1 for four 10-min discrete bouts, each comprising baseline, exposure to active exosuit-applied resistance, and post-active sections. In each bout, a different force magnitude was applied based on individual baseline ankle torques. The peak resistance torque applied by the exosuit was 0.13 ± 0.01, 0.19 ± 0.01, 0.26 ± 0.02, and 0.32 ± 0.02 N m kg−1, in the LOW, MED, HIGH, and MAX bouts, respectively. Results (1) Across all bouts, participants increased peak ipsilateral biological ankle torque by 0.13–0.25 N m kg−1 (p 0.10). Conclusions Targeted resistance of ankle plantarflexion during stance by an exosuit consistently increased local ipsilateral plantarflexor effort during active resistance, but force magnitude will be an important parameter to tune for minimizing the involvement of the unresisted joints and limb during training.