Search

A polymer mode multiplexer based on asymmetric couplers is theoretically designed and experimentally demonstrated. The proposed X-junction coupler is formed by waveguides overlapped with different crossing angles in the vertical direction. A beam propagation method is adopted to optimize the dimensional parameters of the mode multiplexer to convert LP01 mode of two lower waveguides to LP11a and LP21a mode of the upper waveguide. The ultraviolet lithography and wet chemical etching are used in the fabrication process. A conversion ratio over 98% for both LP11a and LP21a mode in the wavelength range from 1530 to 1570 nm are experimentally demonstrated. This mode multiplexer has potential in broadband mode-division multiplexing transmission systems. [ABSTRACT FROM AUTHOR]

A highly sensitive waveguide temperature sensor based on asymmetric Mach–Zehnder interferometer was designed and experimentally demonstrated. The interferometer is based on the polymer/silica hybrid waveguide structure, and Norland Optical Adhesive 73 (NOA 73) was employed as the waveguide core to enhance the temperature sensitivity. The influence of the different length differences between the two interferometer arms on the sensitivity of the sensor was systemically studied. It is shown that the maximum temperature sensitivity of −431 pm °C−1 can be obtained in the range of 25 °C−75 °C, while the length difference is 92 μm. Moreover, the temperature sensitivity contributions from different core materials were also investigated experimentally. It is shown that the waveguide material and microstructure of the device have significant influences on the sensitivity of the waveguide temperature sensor. [ABSTRACT FROM AUTHOR]

An optical waveguide displacement sensor according to core-cladding modes interference is theoretically proposed and experimentally demonstrated. Ultraviolet sensitive SU-8 polymer on silica is used as the guiding layer. It is covered by a 12 nm thick planar gold grating. The air gap sensing head which consists of the waveguide end and the single-mode fiber facet can realize the displacement detection by monitoring the wavelength dip shifting in transmission spectra. Cladding modes propagating in the exposed SU-8 can be effectively excited by the end-fire coupling because of the mode field mismatch between the SU-8 waveguide and lead-in fiber. A sinusoidal pattern transmission spectrum in C-band with the depth of over 14 dB can be observed due to the interference between the core and cladding modes. Peaks in the transmission spectrum vary continuously with the position offset of input fiber facet from the center of waveguide end. Both the sensitivity and the stability of sensing are enhanced by the introduction of nanometric gold gratings. The fabricated displacement sensor exhibits a high sensitivity of 2.3 nm μm−1, promising potentials for micromechanical processing and integrated optics application. [ABSTRACT FROM AUTHOR]

Optical loss induced by the arbitrary structure discontinuity in the Au stripe that supports long-range surface plasmon-polaritons (LRSPPs) propagation is investigated in this paper. A broad range of arbitrary gap sizes, 4 to 20 μm, is reported for 25 nm thick Au stripe with different widths embedded in 5 μm thick optically symmetric polymer SU-8. The simulations and experimental data find a high tunneling efficiency of the long-range mode power transmission of larger than 50% over a 10 μm gap at a wavelength of 1550 nm. Accordingly, a thermally activated in-line Mach–Zehnder interferometer switch based on the guiding of LRSPPs along Au stripe with gaps is designed and fabricated. Switching characteristics are analyzed upon heating one arm of the interferometer through the passage of current therein. The fabricated switch exhibits an extinction ratio of 17 dB with a driving power of 13 mW. The results prove that LRSPPs are insensitive to technological imperfections and waveguide interruptions, which is of benefit to active plasmonic device applications. [ABSTRACT FROM AUTHOR]