Search

We have investigated the interdependence of various factors (particle size, surface smoothness, carrier particle shape, inhalation flow rate) on the deposition of a model drug (salbutamol sulphate) after aerosolization from a model inhaler device (Rotahaler). Different batches of alpha-lactose monohydrate were prepared to have different particle size, particle shape and surface smoothness. Each batch of lactose was then mixed separately with salbutamol sulphate in a ratio of 67.5 : 1 (w/w), under similar conditions. Drug deposition from each formulation was investigated using a 4-stage liquid impinger after aerosolization at 28.3, 60.0 and 96.0 L min(-1) via a Rotahaler. At a flow rate of 28.3 L min(-1), a large portion of drug particles was not emitted from the inhaler, the % emission varying from 29.6% to 66.6% for all formulations investigated. Drug emission tended to increase with particle size of the carrier whilst fine particle fraction, fine particle dose and dispersibility appeared to increase with decreasing particle size but increasing elongation ratio of the carrier particles. Increasing the flow rate to 60.0 L min(-1) was shown to increase drug emission since > 75% total dose was found to be emitted from the inhaler. Again, smaller or more elongated lactose particles resulted in a higher fine particle dose or fine particle fraction of salbutamol sulphate than the coarser carrier, although they produced a similar (analysis of variance P > 0.05) drug emission. Increasing the flow rate to 96.0 L min(-1) did not increase drug emission. Increasing the flow rate resulted in an increase in the fine particle fraction and fine particle dose of salbutamol sulphate from all formulations. The flow rate of the airstream appeared to play the most important role, followed by particle size and elongation ratio of the carrier particles, with the surface smoothness relatively less significant in determining the deposition of salbutamol sulphate from the Rotahaler.

Lactose has been widely used as a carrier for inhalation aerosols. The carrier morphology is believed to affect the delivery of the drug. The aim of this study was to investigate the effects of crystallization conditions on the morphology of alpha-lactose monohydrate intended for use as the carrier for dry powder aerosols. The crystallization of lactose was carried out from aqueous solutions at different supersaturations, temperatures, different stages of crystallization and in the presence of different water-miscible organic solvents. The majority of lactose crystals were found to be either tomahawk-shaped or pyramidal after crystallization at an initial lactose concentration between 33-43% w/w, but these became prismatic if the lactose concentration was increased to 50% w/w. A further increase in the lactose concentration to 60% w/w led to the preparation of elongated cuboidal crystals. Higher initial lactose concentrations tended to result in the crystallization of more elongated particles. Crystallization at 40 degrees C was shown to prepare lactose crystals with a more regular shape and a smoother surface than those crystallized at 0 degrees C. Lactose particles generated during the later stage of crystallization were found to be more regular in shape with a smoother surface than those prepared in the earlier stage. The addition of 10% (v/v) methanol or ethanol or acetone to the mother liquor increased the growth rate of lactose particles whereas addition of propanol or glycerine inhibited the rate of crystal growth. Lactose crystals prepared in the presence of glycerine were more regularly shaped with a smoother surface than those prepared in the presence of ethanol or acetone. All the resultant crystals were shown to comprise alpha-lactose monohydrate. Lactose crystals could be prepared with a precisely defined morphology by means of carefully controlling the crystallization conditions.