Search

Due to the pattern of growth for electricity consumption, there is a need for developing power networks and transmission lines. The power transmission capacity of lines is limited due to a host of factors. Thus, these lines need series and parallel compensations to reduce losses, increase efficiency, and promote system security. In this paper, flexible alternating current transmission system (FACTS) devices including static VAR compensators (SVC) as parallel compensators, thyristor-controlled series compensation (TCSC) as a series compensator, and high-voltage direct current (HVDC) bonding are modeled. In addition, comprehensive modeling of the simultaneous application of these three devices for load flow is performed, and the effects of these types of compensations are compared. The obtained comprehensive model was implemented on MATLAB software using the Newton–Raphson method on two 9-bus WSCC and 5-bus test system. In this case, the calculation speed and convergence were reduced when compared to applying devices individually due to the increase in equations and the addition of new terms to the load flow equations. Furthermore, more losses were observed in this model, which can probably be improved using an optimal power flow and optimal placement of the devices in the network. [ABSTRACT FROM AUTHOR]

In this paper a method for the development of a static VAR compensator (SVC) control algorithm is presented. The proposed algorithm has been designed with the objective of eliminating the negative impact of electric arc furnaces on the power system. First, a mathematical model of the proposed SVC controller in the d-q synchronous rotating coordinate system is developed. An analysis under dynamic and steady state conditions is also carried out. The efficiency of the presented controller is demonstrated by means of computer simulations of an actual steel-factory network model. The major advantages of the proposed controller are better flicker compensation, increased ability to regulate voltage and the need for only one-point network measurements. [ABSTRACT FROM AUTHOR]

In this paper, a new continuously and linearly controlled capacitive static VAR compensator is proposed for the automatic power factor correction of inductive single phase loads in 220V 50Hz power system networks. The compensator is constructed of a harmonic-suppressed TCR equipped with a new adaptive current controller. The harmonic-suppressed TCR is a new configuration that includes a thyristor controlled reactor (TCR) shunted by a passive third harmonic filter. In addition, the parallel configuration is connected to an AC source via a series first harmonic filter. The harmonic-suppressed TCR is designed so that negligible harmonic current components are injected into the AC source. The compensator is equipped with a new adaptive closed loop current controller, which responds linearly to reactive current demands. The no load operating losses of this compensator are negligible when compared to its capacitive reactive current rating. The proposed system is validated on PSpice which is very close in terms of performance to real hardware. [ABSTRACT FROM AUTHOR]