Search

The main objective of this paper is to demonstrate experimentally that it is possible to improve the thermal comfort and reduce the energy consumption of a building without substantial increase in the weight of the construction materials with the inclusion of phase change materials (PCM). PCM are a suitable and promising technology for this application. This paper presents an experimental setup to test PCM with various typical insulation and construction materials in real conditions in Puigverd de Lleida (Lleida, Spain). Nine small house-sized cubicles were constructed: two with concrete, five with conventional brick, and two with alveolar brick. PCM was added in one cubicle of each typology. For each type of construction specific experiments were done. In all cubicles, free-floating temperature experiments were performed to determine the benefits of using PCM. A Trombe wall was added in both concrete cubicles and its influence was investigated. All brick cubicles were equipped with domestic heat pumps as Heating, Ventilation, and Air Conditioning (HVAC) system; therefore, the energy consumption was registered, providing real information about the energy savings. Results were very good for the concrete cubicles, since temperature oscillation were reduced by up to 4°C through the use of PCM and also peak temperatures in the PCM cubicle were shifted in later hours. In the brick cubicles, the energy consumption of the HVAC system in summer was reduced by using PCM for set points higher than 20°C. During winter an insulation effect of the PCM is observed, keeping the temperatures of the cubicles warmer, especially during the cold hours of the day. [ABSTRACT FROM AUTHOR]

Most of the thermal energy storage systems available on the market use water as a storage medium. The improvement of the storage efficiency results in a higher performance of the whole system, and thermal stratification is commonly used for this purpose. On the other hand, in applications with small temperature changes, phase change materials (PCMs) provide high energy density since the latent heat is much larger than the sensible heat. This is the case of stratified hot water tanks, where the temperature change in the top layer is small as it is held close to the usage temperature. The benefits of using PCMs in a water tank, in terms of energy storage density, have been demonstrated before. The time with available hot water is increased because of the energy stored in the PCMs. The aim of this work is to demonstrate that the use of PCMs in the upper part of a water tank holds or improves the benefit of the stratification phenomenon. Two tanks with the same dimensions were compared during charging and discharging processes. One of them is a traditional water tank and the other is a PCM-water tank (a water tank with a phase change material placed at the top). [ABSTRACT FROM AUTHOR]