Search

TEMPUS is a new detector system being developed for photon science. It is based on the Timepix4 chip and, thus, it can be operated in two distinct modes: a photon‐counting mode, which allows for conventional full‐frame readout at rates up to 40 kfps; and an event‐driven time‐stamping mode, which allows excellent time resolution in the nanosecond regime in measurements with moderate X‐ray flux. In this paper, the initial prototype, a single‐chip device, is introduced, and the readout system described. Moreover, and in order to evaluate its capabilities, some tests were performed at PETRA III and ESRF for which results are also presented. [ABSTRACT FROM AUTHOR]

Mössbauer reflectivity spectra and nuclear resonance reflectivity (NRR) curves have been measured using the Synchrotron Mössbauer Source (SMS) for a [57Fe/Cr]30 periodic multilayer, characterized by the antiferromagnetic interlayer coupling between adjacent 57Fe layers. Specific features of the Mössbauer reflectivity spectra measured with π‐polarized radiation of the SMS near the critical angle and at the `magnetic' maximum on the NRR curve are analyzed. The variation of the ratio of lines in the Mössbauer reflectivity spectra and the change of the intensity of the `magnetic' maximum under an applied external field has been used to reveal the transformation of the magnetic alignment in the investigated multilayer. [ABSTRACT FROM AUTHOR]

The design of a 57Fe Synchrotron Mössbauer Source (SMS) for energy-domain Mössbauer spectroscopy using synchrotron radiation at the Nuclear Resonance beamline (ID18) at the European Synchrotron Radiation Facility is described. The SMS is based on a nuclear resonant monochromator employing pure nuclear reflections of an iron borate (57FeBO3) crystal. The source provides 57Fe resonant radiation at 14.4 keV within a bandwidth of 15 neV which is tunable in energy over a range of about ±0.6 µeV. In contrast to radioactive sources, the beam of γ-radiation emitted by the SMS is almost fully resonant and fully polarized, has high brilliance and can be focused to a 10 µm × 5 µm spot size. Applications include, among others, the study of very small samples under extreme conditions, for example at ultrahigh pressure or combined high pressure and high temperature, and thin films under ultrahigh vacuum. The small cross section of the beam and its high intensity allow for rapid collection of Mössbauer data. For example, the measuring time of a spectrum for a sample in a diamond anvil cell at ∼100 GPa is around 10 min, whereas such an experiment with a radioactive point source would take more than one week and the data quality would be considerably less. The SMS is optimized for highest intensity and best energy resolution, which is achieved by collimation of the incident synchrotron radiation beam and thus illumination of the high-quality iron borate crystal within a narrow angular range around an optimal position of the rocking curve. The SMS is permanently located in an optics hutch and is operational immediately after moving it into the incident beam. The SMS is an in-line monochromator, i.e. the beam emitted by the SMS is directed almost exactly along the incident synchrotron radiation beam. Thus, the SMS can be easily utilized with all existing sample environments in the experimental hutches of the beamline. Owing to a very strong suppression of electronic scattering for pure nuclear reflections (∼10−9), SMS operation does not required any gating of the prompt electronic scattering. Thus, the SMS can be utilized in any mode of storage ring operation. [ABSTRACT FROM AUTHOR]

The performance of an indirectly cooled cryogenic silicon monochromator under heat loads up to 870 W has been studied. The investigation was performed over numerous parameters and included measurements of total flux, spectral density, rocking curves, angular beam profiles and crystal slope errors. An almost ideal monochromator performance was observed in the 270-570 W range of the heating power. At a heat load of ∼400 W and under standard operation conditions, the crystal distortions did not exceed 1 µrad. At the highest available heat load of 870 W, the crystal distortions were about 7 µrad. [ABSTRACT FROM AUTHOR]