Search

MWCNT/alumina composites were prepared by a flocculation method combined with acid treatment of the MWCNTs and spark plasma sintering. The effects of varying the processing conditions, namely the acid treatment temperature (50–80 °C), MWCNT content (0–10 vol.%) and sintering temperature (1200–1600 °C) on the composites’ microstructure, electrical conductivity and mechanical properties were investigated. This found that flocculation processing brings about a good dispersibility of the MWCNTs, especially with higher acid treatment temperature, which enhances their reinforcing and grain refining effect. When combined with a low sintering temperature, this significantly improves the mechanical properties of the composites.As a result, a composite prepared using a sintering temperature of 1200 °C and an acid treatment temperature of 80 °C exhibited a fracture toughness greater than that of a monolithic alumina, even with a MWCNT content as high as 10 vol.%. [ABSTRACT FROM AUTHOR]

In order to overcome intrinsic brittleness and poor mechanical properties of fused silica (FS), boron nitride nanosheets (BNNSs) as a novel reinforcement were employed for fabrication of BNNSs/fused silica composites. BNNSs with micron lateral size were homogeneously dispersed with FS powder using a surfactant-free flocculation method and then consolidated by hot pressing. The flexural strength and fracture toughness of the composite with the addition of only 0.5 wt.% BNNSs increased by 53% and 32%, respectively, compared with those of pure FS. However, for higher BNNSs contents the improvement in mechanical properties was limited. Microstructural analyzes have shown that the toughening mechanisms are combinations of the pull-out, crack bridging, and crack deflection mechanisms. [ABSTRACT FROM AUTHOR]