Search

In this paper, Ni0.5Zn0.5Fe2O4ferrite ceramics were produced with Ni0.5Zn0.5Fe2O4powders prepared by reaction in a molten salt using Fe2O3, NiO and ZnO powders as raw materials. Ni-Zn powders were characterized by X-ray diffraction (XRD). Density and shrinkage in diameter of Ni0.5Zn0.5Fe2O4ceramics were measured. MicroSubscript text structures were observed using field emission scanning electron microscopy (FESEM), and magnetic properties were examined by HP4291B impedance analyzer. XRD pattern indicated that the powders synthesized at 900°C for 1h were pure spinel Ni0.5Zn0.5Fe2O4phase. Via the measurement of density and shrink in diameter, optimal temperature was 1200°C and holding time was 2h, which was in accord with the results concluded from micrographs. FESEM images illustrated that the average grain size increased with increasing holding time, which followed the Ostwald liquid growth mechanism. At lower frequencies, the initial permeability (μi) increased from 86.65 to 183.48 with increasing holding time, while the threshold frequency decreased from 13.3MHz to 8.52MHz, which implied the initial permeability (μi) variation complied with the Snoek law to some extent.

A novel rapid prototyping manufacturing technology for glass-alumina functionally gradient materials (G-A FGMs) based on the quick solidification of wax was proposed. The feature of the technology came from its layer-by-layer fabrication of the wax-glass/alumina composite layer carved in accordance with the shape of each layer of the computer designed model and in situ casting of wax into the carved area. Removal of the wax in the G-A FGMs green body was investigated based on differential scanning calorimetry (DSC) analysis. Sintering properties of the G-A FGMs were discussed. Bending strength of the G-A FGMs was measured by a three-point flexural test. Microstructures of the prepared G-A FGMs were observed using environmental scanning electron microscope (ESEM) and the compositional distribution was determined according to energy dispersive spectrum (EDS). Samples were preliminarily and respectively held at 200°C and 300°C for a long time based on the DSC analysis. The range of the optimal sintering temperature is determined to be from 710°C to 720°C and the holding time is 30min. With the increasing alumina content, the bending strength increases and the maximum bending strength is 67.5MPa. There is no delamination of the G-A FGMs via ESEM. Homogeneous distribution of the ingredient materials is confirmed through EDS.

Numerical modeling on falling of sodiumtetraborate aqueous solution drops as the initiator before the gelation of PVA-TiO2 suspensions was conducted. Effect of time and elevation angle of the PVA-TiO2 suspensions on the falling velocity of the sodiumtetraborate aqueous solution drops was analyzed. An ordinary differential equation was given. Integration of the ordinary differential equation was fulfilled using the fourth-order Runge-Kutta method in Matlab 6.5. From the model, a two-order nonlinear effect of time on the velocity of the drops during falling is determined and the quadratic term -3.408t2 serves as the time dependent air resistance. The component of the falling velocity along the suspensions increases with the increasing of the elevation angle. However, for the component vertical to the suspensions, with elevation angle increasing, it decreases.