Search

On October 2017, due to continuous rainfall, there was a massive river blockage induced by a landslide in Guang'an Village, Chongqing, China. Long-term monitoring analysis has shown that there remain four strong deformation areas on the slope, which seriously threaten the life and property of nearby residents. In this paper, a granular flow model and an elasto-visco-plasticity model were applied to reproduce and predict the landslide event that hit Guang'an Village. The results showed that the landslide gradually moved along the sliding surface, pushing loose deposits and blocking the Xixi River. The numerical reproduction results of the 2017 event are consistent with the actual slope deformation and failure process and deposit morphology. The simulated maximum depth-averaged velocity of this landslide was approximately 1.89 m/s, and the height of the landslide dam was approximately 10 m. After the landslide occurred in 2017, several large deformation areas appeared in the vicinity of the sliding area, and the right rear side of the sliding mass in area III has the largest deformation volume, accompanied by the most developed surface crack and the most intense deformation. There is a risk that the Xixi river will be blocked again. Therefore, with the same parameter and numerical model, a sliding–pushing–blocking dynamic prediction analysis of the strong deformation area III was conducted. The pushing motion of the mass in this area will reactivate the landslide mass observed in 2017. The maximum depth-averaged velocity of deformation area III was 0.5 m/s, and the maximum depth-averaged velocity of landslide deposition was 0.45 m/s. The length of the blocking dam formed by the mass of deformation area III along river was approximately 780 m, 30 m longer than that in 2017. The predicted height of the landslide dam was 14.5 m, approximately 4.5 m higher than that in 2017. The length of the landslide dam reservoir was predicted to be 2.55 km along the Xixi River, which may submerge the Waping Village. This study supports the landslide hazard prevention, reveals the whole movement process of sliding-pushing-blocking, and provides a new research idea and method for the landslide movement prediction. Hence, this study can serve as a reference for the hazard prevention and mitigation of such chain disasters. [ABSTRACT FROM AUTHOR]

The paper ‘Guidelines on the use of inverse velocity method as a tool for setting alarm thresholds and forecasting landslides and structure collapses’ by T. Carlà, E. Intrieri, F. Di Traglia, T. Nolesini, G. Gigli and N. Casagli deals with a sensitive topic for landslide risk management. Exploring the pre-failure behaviour of four different case histories, the authors proposed standard procedures for the application of the inverse velocity method (INV, Fukuzono 1985). Specifically, they suggested guidelines for the filtering of velocity data and an original and simple approach to automatically set the first and the second alarm thresholds using the inverse velocity method. The present discussion addresses three different topics: (1) data filter selection according to the features of monitoring instrument; (2) the importance of data sampling frequency for the forecasting analysis and (3) the influence of the starting point (SP in this discussion) for the application of INV analysis. Moreover, based on this matter, a new method is proposed to update the INV analysis on an ongoing basis. [ABSTRACT FROM AUTHOR]

The monitoring of landslides has a practical application for the prevention of hazards, especially in the case of large deep-seated landslides. Monitoring data are necessary to understand the relationships between movement and triggers, to predict movement, and to establish an early warning system. This paper compares two phenomenological models for the prediction of the movement of the Kostanjek landslide, the largest landslide in the Republic of Croatia. The prediction models are based on a 4-year monitoring data series of landslide movement, groundwater level, and precipitation. The presented models for landslide movement prediction are divided into the model for the prediction of groundwater level from precipitation data and the model for the prediction of landslide velocity from groundwater level data. The statistical techniques used for prediction are multiple linear regression and random forests. For the prediction of groundwater level, 75 variables calculated from precipitation and evapotranspiration data were used, while for the prediction of landslide movement, 10 variables calculated from groundwater level data were used. The prediction results were mutually compared by k-fold cross-validation. The root mean square error analyses of k-fold cross-validation showed that the results obtained from random forests are just slightly better than those from multiple linear regression, in both, the groundwater level and the landslide velocity models, proofing that multiple linear regression has a potential for prediction of landslide movement. [ABSTRACT FROM AUTHOR]

This paper presents a new region-based preparatory factor, total flux ( TF), for landslide susceptibility models (LSMs). TF takes into account the topography and hydrology conditions upstream of each gridded data cell and represents the total flux of water in the stream. The results show that TF is strongly associated with the occurrence of landslides and is a good preparatory factor for LSM. Using TF instead of a drainage distance factor in I-Lan region in Taiwan shows an improvement in the accuracy of the cumulative percentage of landslide occurrence of 44 and 14 % for the top 1 and 10 % susceptible areas, respectively. This significant improvement in accuracy in these high-risk areas is critical for preventing and mitigating the economic and human losses due to landslides. [ABSTRACT FROM AUTHOR]

Early warning systems for slope instability are needed to alert users of accelerating slope deformation behaviour, enable evacuation of vulnerable people, and conduct timely repair and maintenance of critical infrastructure. Communities exposed to landslide risk in low- and middle-income countries seldom currently instrument and monitor slopes to provide a warning of instability because existing techniques are complex and prohibitively expensive. Research and field trials have demonstrated conclusively that acoustic emission (AE) monitoring can be an effective approach to detect accelerating slope movements and to subsequently communicate warnings to users. The objective of this study was to develop and assess a simple, robust, low-cost AE monitoring system to warn of incipient landslides, which can be widely deployed and operated by communities globally to help protect vulnerable people. This paper describes a novel AE measurement sensor that has been designed and developed with the cost constrained to a few hundred dollars (US). Results are presented from physical model experiments that demonstrate performance of the AE system in measuring accelerating deformation behaviour, with quantifiable relationships between AE and displacement rates. Exceedance of a pre-determined trigger level of AE can be used to communicate an alarm to users in order to alert them of a slope failure. Use of this EWS approach by communities worldwide would reduce the number of fatalities caused by landslides. [ABSTRACT FROM AUTHOR]

Landslides are among the most common and dangerous natural hazards in mountainous regions that can cause damage to properties and loss of lives. Landslide susceptibility mapping (LSM) is a critical tool for preventing or mitigating the negative impacts of landslides. Although many previous studies have employed various statistical methods to produce quantitative maps of the landslide susceptibility index (LSI) based on inventories of past landslides and contributing factors, they are mostly ad hoc to a specific area and their success has been hindered by the lack of a methodology that could produce the right mapping units at proper scale and by the lack of a general framework for objectively accounting for the differing contribution of various preparatory factors. This paper addresses these issues by integrating the geomorphon and geographical detector methods into LSM to improve its performance. The geomorphon method, an innovative pattern recognition approach for identifying landform elements based on the line of sight concept, is adapted to delineate ridge lines and valley lines to form slope units at self-adjusted spatial scale suitable for LSM. The geographical detector method, a spatial variance analysis method, is integrated to objectively assign the weights of contributing factors for LSM. Applying the new integrated approach to I-Lan, Taiwan produced very significant improvement in LSI mapping performance than a previous model, especially in highly susceptible areas. The new method offers a general framework for better mapping landslide susceptibility and mitigating its negative impacts. [ABSTRACT FROM AUTHOR]

■■■The paper “Discussion to: Guidelines on the use of inverse velocity method as a tool for setting alarm thresholds and forecasting landslides and structure collapses by T. Carlà, E. Intrieri, F. Di Traglia, T. Nolesini, G. Gigli and N. Casagli” by Bozzano et al. brings forward new considerations on an issue of extreme concern in landslide risk management. To this day, the ability to predict catastrophic landslide failures from slope surface displacements is a problem dictated more by practical constraints rather than by theoretical uncertainties. In this sense, the development of data interpretation practices is crucial. This short reply provides a few further insights with regard to this subject, also in the context of the recently published literature. [ABSTRACT FROM AUTHOR]

On September 5, 2022, an Ms6.8 earthquake struck Luding County, Sichuan Province, China. Through creating a coseismic landslide prediction model, we obtained the spatial distribution of the triggered geological hazards immediately after the earthquake. Through collecting all available multi-source optical remote sensing images of the earthquake-affected area via UAV and satellite platforms, the exact information of coseismic landslide was achieved by pattern recognition and visual inspection. According to the current results, the Luding earthquake triggered 5336 landslides with a total area of 28.53km2. The spatial distribution of the coseismic landslides is correlated statistically to various seismic, terrain, and geological factors, to evaluate their susceptibility at regional scale and to identify the most typical characteristics of these failures. The results reveal that the coseismic landslides mainly occurred on the sides of the Xianshuihe fault (within 1.2 km) and Dadu River (within 0.5 km) in striped patterns. They are concentrated in the regions with an elevation range of 1000–1800 m, a slope range of 25–55°, and lithologies of acid plutonic rocks, mixed sedimentary rocks, and siliciclastic sedimentary rocks. Besides, the coseismic landslides of the Luding earthquake are smaller in size and shallower than those triggered by the 2008 Wenchuan earthquake and the 2017 Jiuzhaigou earthquake. Rapidly achieving the spatial locations and distribution patterns of the coseismic landslides enables to provide effective support and guidance to emergency rescue, risk mitigation, and reconstruction planning. [ABSTRACT FROM AUTHOR]

Landslides have claimed many lives and caused significant economic losses in recent years. Therefore, assessing the potential risk for landslide hazard prevention and mitigation is vital and the landslide travel distance is a key aspect in this process. In this study, the group method of data handling (GMDH) was used to predict the landslide travel distance. A total of 111 landslide datasets collected from the literature were used to construct and validate the proposed GMDH model. Five parameters were selected as the input parameters, including initial slope angle, body height, average body thickness, the logarithm of source volume, and body aspect ratio. The GMDH model was compared with the gene expression programming (GEP) model as well as four empirical models proposed by other researchers. The comparison results demonstrated that the predicted results of the GMDH model agreed well with the measured values, with a correlation coefficient of 0.9123, which was higher than the GEP model and the four empirical models. It was concluded that the proposed GMDH model had great potential in estimating the landslide travel distance. [ABSTRACT FROM AUTHOR]

Seismic slope stability analysis at regional scale (e.g., landslide hazard mapping, infrastructure slope management) is essential in areas that are susceptible to earthquake. Analytical infinite slope model is well suited and widely used for regional analyses which involve hundreds and thousands of slopes. Use of infinite slope model implicitly assumes shallow translational failure mechanism. However, earthquake can also cause deep rotational failure, which is more destructive and should also be considered. This study aims to develop closed-form solutions that can be efficiently used for seismic slope stability analysis at regional scale considering deep rotational failure mechanism. The existing research is critically reviewed first, and their shortcomings are identified. In contrast to the conventional "two-step" approach, a more efficient and versatile "one-step" approach is proposed in this study. The "one-step" approach can be used to calculate factor of safety for pseudo-static analysis and yield coefficient for displacement-based seismic analysis. To consider the effects of uncertainty from soil properties and seismic loading, the "one-step" approach is further extended for probabilistic analysis and application is demonstrated through a case study. The efficiency and versatility of the proposed "one-step" approach make it well suited for regional seismic slope stability analysis. [ABSTRACT FROM AUTHOR]

Landslides are dangerous and destructive geomorphic processes that cause annual damage to human infrastructure or even loss of life. As recovery is very costly, knowledge of past landslide activities, a detailed analysis of triggers and prediction of future landslide development are important. Dendrogeomorphic (tree-ring-based) dating is the best solution of chronological data obtaining in forested areas, where trees annually produce increment rings. A moving landslide mass affects trees that grow on its surface. Trees respond to this influence in different ways that are recordable and subsequently visible in tree ring series. Thus, tree rings represent an ideal natural archive of past landslide behaviour. Depending on the tree species, the length of a landslide chronology can be several centuries with sub-annual resolution. Although dendrogeomorphic approaches have some limitations, provided data are unique because they represent insight into the past without the need for long-term monitoring. Nevertheless, trees as landslide archives are suitable for medium-magnitude events because excessively small movements can be disregarded and catastrophic movements destroy trees. This review introduces details regarding tree-landslide interactions, provides a historical overview of applied methods, presents and assesses methodical approaches and summarises basic advantages and contributions to the knowledge of landslide chronology, spatial behaviour and triggers. Finally, limitations, the potential for subsequent research directions and calls for future fundamental studies in new world regions are presented. [ABSTRACT FROM AUTHOR]