Search

On August 14, 2020, it occurred a landslide-induced debris flow in Wangcang County, Sichuan Province, Southwest China, three people killed, and two houses destroyed. Behaved as a typical geohazard chain, it originated from a rockslide in marlstone, controlled initially by structural planes in rock mass, and evolved into a debris flow through successive geophysical process. This debris flow reached a run-out distance of 2050 m in the horizontal and 628 m in vertical direction. Remote sensing analysis, field survey, and laboratory tests were conducted to investigate its failure mechanism and dynamic characteristics. The results found that the source zone in the gully was 16.32 × 103 m2, with a volume of 317.52 × 103 m3. Interbedded marlstone with dense structural planes was one of controlling factors for the landslide failure. The continuous rainfall up to 315 mm during the previous 24 days and 32 mm at the date before the incident directly motivated rock slope failure. The contributions of topography, rock fragmentation, entrainment, and flow discharge for this process were discussed. It is found that changes in slope from 11° to 40° provided tremendous potential energy for the rock mass sliding with high speed and then disintegrating in traveling. Entrainment in the channel increased the fine content of the moving rocky mixture. In addition, the flow discharge changed the rheological properties of the mixture by adding seepage. These factors significantly affected the transformation process. Notably, the turning relief or confluence site may be accelerating this process. This research may provide references for further research on geohazard chains. [ABSTRACT FROM AUTHOR]

In this study, we carried out a series of physical experiments using a submersed flume model to investigate how sand/clay content influences the depositional mechanism of submarine debris flows. A three-dimensional biphasic numerical model, with a Herschel-Bulkley rheology, was used to back-analyze the physical experiments. The calibrated numerical model was then used in a back-calculation to investigate the effects of viscosity on the deposition process. The results show that as submarine debris flows mix with water during the deposition process, shear stress at the slurry-water interface generates a vortex that leads to a swirl-wedge front head. High-viscosity slurry flows with a swirl-wedge front head travel at a higher aspect ratio and with a greater radius of rotation. Hydroplaning was observed when the front head was lifted by water during flow. The lifting height increased with flow depth fluctuation. Higher viscosity slurry was found to lift more rapidly due to its larger vortex and the decrease in density at the front head over time, both of which promote fluctuation. Although a high-density slurry has a greater lifting height, the ratio of lifting height to front head height is lower, indicating a smaller lifting force influence. Lower density flows have higher kinetic energy as the transfer of potential energy into kinetic energy is more efficient. Kinetic energy dissipation comprises three stages: (1) gravity-dominated coherent flow and hydroplaning lead to a rapid increase in kinetic energy; (2) sharp reduction in kinetic energy as slurry mixes with water, coherence and hydroplaning are reduced, and the influence of the shear stress increases; (3) slurry mixed very well with water, turbidity current dominates the kinetic energy dissipation. High-density slurry dissipates quicker in the last two stages. In stage 3, which dominates the temporal evolution of the debris flow, the Froude number is lower than 1, the flow thins and elongates, and the deposition process of submarine debris flows is dominated by gravity, and the difference of morphology of the different cases become clear. [ABSTRACT FROM AUTHOR]