Search

Cationic amphiphilic polymers have been a platform to create new antimicrobial materials that act by disrupting bacterial cell membranes. While activity characterization and chemical optimization have been done in numerous studies, there remains a gap in our knowledge on the antimicrobial mechanisms of the polymers, which is needed to connect their chemical structures and biological activities. To that end, we used a single giant unilamellar vesicle (GUV) method to identify the membrane-disrupting mechanism of methacrylate random copolymers. The copolymers consist of random sequences of aminoethyl methacrylate and methyl (MMA) or butyl (BMA) methacrylate, with low molecular weights of 1600-2100 g·mol-1. GUVs consisting of an 8:2 mixture of 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine (POPE) and 1-palmitoyl-2-oleoyl-sn-glycero-3-phospho-(1'-rac-glycerol), sodium salt (POPG) and those with only 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC) were prepared to mimic the bacterial (Escherichia coli) or mammalian membranes, respectively. The disruption of bacteria and mammalian cell membrane-mimetic lipid bilayers in GUVs reflected the antimicrobial and hemolytic activities of the copolymers, suggesting that the copolymers act by disrupting cell membranes. The copolymer with BMA formed pores in the lipid bilayer, while that with MMA caused GUVs to burst. Therefore, we propose that the mechanism is inherent to the chemical identity or properties of hydrophobic groups. The copolymer with MMA showed characteristic sigmoid curves of the time course of GUV burst. We propose a new kinetic model with a positive feedback loop in the insertion of the polymer chains in the lipid bilayer. The novel finding of alkyl-dependent membrane-disrupting mechanisms will provide a new insight into the role of hydrophobic groups in the optimization strategy for antimicrobial activity and selectivity.

The monolayer properties of some single-chain polyprenyl phosphates (phytanyl, phytyl, and geranylgeranyl phosphates), which we regard as hypothetical primitive membrane lipids, were investigated at the air-water interface by surface pressure-area (pi-A) isotherm measurements. The molecular area/ pressure at various pH conditions dependence revealed the acid dissociation constants (pKa values) of the phosphate. The pKa values thus obtained at the air-water interface (pKa1 = 7.1 and pKa2 = 9.4 for phytanyl phosphate) were significantly shifted to higher pH than those observed in the bilayer state in water (pKa1 = 2.9 and pKa2 = 7.8). The difference in pKa values leads to a stability of the phosphate as both monolayer and bilayer states in a pH range of 2-6. In addition, the presence of ions such as sodium, magnesium, calcium, and lanthanum in the subphase significantly altered the stability of the polyprenyl phosphate monolayers, as shown by the determination of monolayer collapse and compression/expansion hysteresis. Although sodium ions in the subphase showed only a weak effect on the stabilization of the monolayer, addition of magnesium ions or of a small amount of calcium ions significantly suppressed the dissolution of the monolayer into the subphase and increased its mechanical stability against collapse. In contrast, the presence of larger amounts of calcium or of lanthanum ions induced collapse of the monolayers. Based on these experimental facts, a plausible scenario for the formation of primitive cell membrane by transformation of a monolayer to vesicle structures is proposed.

The steroid cyclophanes with a cyclic core consisting of a 1,6,20,25-tetraaza[6.1.6.1]paracyclophane connected to four steroid moieties (cholic acid or cholanic acid) through a flexible l-lysine spacer were spread on water as Langmuir monolayers. The pi-A isotherm of the cholic-type steroid cyclophane includes a transition to the condensed phase with a limiting area of approximately 2 nm(2). This value is close to the cross-sectional area of the steroid cyclophane with a standing-up conformation of the cholic acid moieties, strongly suggesting that the cavity converts from a two-dimensional cavity to a three-dimensional cavity upon compressing the monolayer. Surface-reflective fluorescence spectroscopy of the monolayer using an aqueous fluorescent probe (6-(p-toluidino)naphthalene-2-sulfonate (TNS)) showed an abrupt increase in the TNS fluorescence intensity at a molecular area of 2 nm(2). Efficient binding of the guest probe would occur upon the completion of the three-dimensional cavity. Repeated compression and expansion induces periodic changes in the fluorescence intensity. This indicates a piezoluminescence effect through the catch and release of the TNS guest upon dynamic cavity formation. Analyses of the binding behavior of TNS to the steroid cyclophane resulted in binding constants in the range of approximately (5-9) x 10(4) M(-1) which are similar to that observed in lipid bilayer media (K = 5.1 x 10(4) M(-1)). The fluorescence intensity within the condensed phase was significantly increased with increasing pressure, suggesting that suppression of the molecular motion of the bound TNS may retard the nonemission process. Similar monolayer experiments were carried out with the monolayer of the cholanic-type steroid cyclophane that cannot form an open conformation on water. Both the phase transition in the pi-A isotherm and the change in the fluorescence intensity were negligible, confirming that the dynamic characteristic of the cavity is indispensable for the efficient pressure-induced binding of the guest and the consequent luminescence.

We have developed a novel approach for forming dendrimer monolayers. A Lys-Lys-Glu tripeptide with a dioctadecylamino tail at the C-terminal and an acetyl head at the N-terminal was newly synthesiz...

In this paper, we demonstrated that supramolecular structures of amphiphilic tripeptides can be effectively modulated by selecting the appropriate casting solvents. The tripeptide derivatives having an ammonium head and hydrophobic tails were dispersed in three kinds of solvents (nonpolar, medium nonpolar, and polar) followed by casting the solutions onto fleshly cleaved mica. The supramolecular structures in the cast films were observed using an atomic force microscope (AFM). The tripeptide derivative possessing the Ala-Ala-Glu sequence formed needles with nanometer-scale width, micrometer-scale rods, and patterns with molecular-level flatness by casting from H2O, CCl4, and CHCl3, respectively. Since the major driving forces of the assembly are significantly influenced by the polarity of the surrounding media, the assembling process can be altered depending on the nature of the solvents. In polar H2O, the hydrophobic interaction is dominant and the resulting assemblies are supported by hydrogen bonding. ...

In this letter, we report that single-walled carbon nanotubes (SWNTs) can be dissolved in organic solvents through the formation of admixtures with barbituric acid.triaminopyrimidine (BA.TP) complexes using mechanochemical high-speed vibration milling (HSVM) and sonication methods. In contrast, neither BA nor TP alone were capable of solubilizing SWNTs. Moreover, the glutarimide (GI).TP complex was also found to be incapable of solubilizing SWNTs because the two carbonyl groups and one imino group of GI are located on only one side of the molecule such that the GI.TP complex cannot form the desired hydrogen-bonding network. These results strongly suggest that the formation of a hydrogen-bonding network makes possible the formation of multipoint interactions with the surfaces of the SWNTs.