Search

Background and Objective: Endoscopic third ventriculostomy is used to treat hydrocephalus. Different laser wavelengths have been proposed for laser-assisted endoscopic third ventriculostomies over the last decades. The aim of this study was to evaluate Thulium laser endoscopic third ventriculostomy heat penetration in the surrounding environment of the floor of the third ventricle in an in vitro setting with visualization of thermal distribution. Subsequently 106 Thulium laser endoscopic third ventriculostomy procedures were retrospectively analyzed to demonstrate safety. Methods: The in vitro visualization was based on the color Schlieren method. The heat penetration was measured beneath a tissue phantom of the floor of the third ventricle with a fiber of 365 μm in diameter at different energy settings; 1.0W (956 J/cm2), 2.0W (1,912 J/cm2), 4.0W (3,824 J/cm2), and 7.0W (6,692 J/cm2), with a pulse duration of 1.0 second. All experiments were repeated five times. In addition, 106 Thulium laser endoscopic third ventriculostomy procedures between 2005 and 2015 were retrospectively analysed for etiology, sex, complications, and laser parameters. Results: In the energy settings from 1.0 to 4.0 W, heat penetration depth beneath the phantom of the third ventricle did not exceed 1.5 mm. The heat penetration depth at 7 W, exceeded 6 mm. The clinical overall success rate was 80% at the 2-year follow-up study. Complications occurred in 5% of the procedures. In none of the 106 investigated clinical patients bleeding or damage to the basilar artery was encountered due to Thulium laser ablation. Conclusions: The in vitro experiments show that under 4.0W the situation is considered safe, due to low penetration of heat, thus the chance of accidentally damaging critical structures like the basilar artery is very small. The clinical results show that the Thulium laser did not cause any bleeding of the basilar artery, and is a safe technique for laser endoscopic third ventriculostomy. Lasers Surg. Med. 50:629–635, 2018. © 2017 Wiley Periodicals, Inc.

Background and Objectives: Topical drug delivery can be increased by pretreatment of the skin with ablative fractional laser (AFXL). Several physical penetration enhancement techniques have been investigated to further improve AFXL-assisted drug delivery. This study investigated the influence of three of these techniques, namely massage, acoustic pressure wave treatment, and pressure vacuum alterations (PVP) on the distribution of the fluorescent drug indocyanine green (ICG) at different depths in the skin after topical application on AFXL pretreated skin. Materials and Methods: In ex vivo human skin, test regions were pretreated with AFXL (10,600 nm, channel depth 300 μm, channel width 120 μm, density 15%). Subsequently, ICG was applied, followed by massage, acoustic pressure wave treatment or PVP. ICG fluorescence intensity (FI) was assessed after 1, 3, and 24 hours at several depths using fluorescence photography. Results: FI was higher when using enhancement techniques compared to control (AFXL-only) up to 3 hours application time (P < 0.05). After 3 hours, mean surface FI was highest after acoustic pressure wave treatment (61.5 arbitrary units; AU), followed by massage (57.5AU) and PVP (46.9AU), respectively (for comparison: AFXL-only 31.6AU, no pretreatment 14.9AU). Comparable or higher FI was achieved already after 1 hour with enhancement techniques compared to 3–24 hours application time without. After 24 hours, no significant differences between enhancement techniques and AFXL-only were observed (P = 0.31). Conclusion: Penetration enhancement techniques, especially acoustic pressure wave treatment and massage, result in improved drug accumulation in AFXL-pretreated skin and reduce the application time needed. Lasers Surg. Med. © 2019 The Authors. Lasers in Surgery and Medicine Published by Wiley Periodicals, Inc.

Background and Objective: Endoscopic third ventriculostomy is used to treat hydrocephalus. Different laser wavelengths have been proposed for laser-assisted endoscopic third ventriculostomies over the last decades. The aim of this study was to evaluate Thulium laser endoscopic third ventriculostomy heat penetration in the surrounding environment of the floor of the third ventricle in an in vitro setting with visualization of thermal distribution. Subsequently 106 Thulium laser endoscopic third ventriculostomy procedures were retrospectively analyzed to demonstrate safety. Methods: The in vitro visualization was based on the color Schlieren method. The heat penetration was measured beneath a tissue phantom of the floor of the third ventricle with a fiber of 365 μm in diameter at different energy settings; 1.0W (956 J/cm2), 2.0W (1,912 J/cm2), 4.0W (3,824 J/cm2), and 7.0W (6,692 J/cm2), with a pulse duration of 1.0 second. All experiments were repeated five times. In addition, 106 Thulium laser endoscopic third ventriculostomy procedures between 2005 and 2015 were retrospectively analysed for etiology, sex, complications, and laser parameters. Results: In the energy settings from 1.0 to 4.0 W, heat penetration depth beneath the phantom of the third ventricle did not exceed 1.5 mm. The heat penetration depth at 7 W, exceeded 6 mm. The clinical overall success rate was 80% at the 2-year follow-up study. Complications occurred in 5% of the procedures. In none of the 106 investigated clinical patients bleeding or damage to the basilar artery was encountered due to Thulium laser ablation. Conclusions: The in vitro experiments show that under 4.0W the situation is considered safe, due to low penetration of heat, thus the chance of accidentally damaging critical structures like the basilar artery is very small. The clinical results show that the Thulium laser did not cause any bleeding of the basilar artery, and is a safe technique for laser endoscopic third ventriculostomy. Lasers Surg. Med. 50:629–635, 2018. © 2017 Wiley Periodicals, Inc.

Background and Objectives A key element in the Excimer Laser Assisted Non-occlusive Anastomosis (ELANA) technique is the retrieval of a disc (“flap”) of artery wall from the anastomosis by the laser catheter tip. We assessed if the flap retrieval rate could be optimized. Methods We used a specially designed in vitro model using rabbit aortas. We tested three essential elements of the technique: (1) laser energy (10, 13, 15, or 18 mJ), (2) pressure on the catheter (0, 0.1, 0.2, or 0.4 N), and (3) number of lasing episodes (1 or 2). We made 2,280 anastomoses using different combinations of settings. With a logistic regression model we assessed the influence of each parameter. Current clinical settings (10 mJ, 0.2 N, 1 episode) were reference categories. Results Flap retrieval rate using conventional settings was 86.7%, equivalent to earlier reported clinical data. A significantly higher flap retrieval appeared when laser energy was increased to 13 mJ (OR 3.0, 95% CI 1.8–4.8), 15 mJ (OR 3.2, 95% CI 1.9–5.3), and 18 mJ (OR 3.7, 95% CI 2.2–6.2). A second lasing episode also significantly increased flap retrieval (OR 2.1, 95% CI 1.4–3.0). However, if we increased energy to 15 or 18 mJ, the effect of a second laser episode was insignificant. When the catheter was pushed down with 0.4 N, flap retrieval decreased significantly in all subgroups (OR 0.07, 95% CI 0.04–0.14). Conclusion The flap retrieval of the ELANA anastomosis technique can be optimized to 100% by setting the laser energy at 15 mJ. However, safety studies are necessary before clinical application. A second lasing episode of 10 mJ is a good alternative to increase the flap retrieval. Moreover, the surgeon should be trained to apply not more than 0.2 N on the catheter. Lasers Surg. Med. 42:418-424, 2010. © 2010 Wiley-Liss, Inc.

For laser angioplasty probes, the thermal properties of the probes will primarily determine their mechanism of action. We examined the absorption, temperature increase, and probe degradation of transparent contact probes (hemispherical contact probe and ball-shaped fibers) and metal laser probes coupled to a continuous-wave Nd-YAG laser. Temperature was recorded by means of thermocouples and the measurements were corrected for direct light absorption by the thermocouple. During 15 W, 1 s exposure, the peak temperature rise of the hemispherical contact probe in contact with tissue dropped from approximately 1,000 degrees C at the front end to below 45 degrees C (95% drop) at the lateral side. In contrast, during continuous exposure the peak temperature rise of metal laser probes in contact with tissue dropped from 560 degrees C at the front end to near 400 degrees C (30% drop) at the 5.5 mm proximal rear end. During exposure in blood or tissue, the transparent contact probes became contaminated. Their absorption increased from 5 to 33% and the probe deteriorated. Repeated use of metal laser probes in blood resulted in a higher temperature at the rear than at the front end due to backburing of the fiber. Owing to the large temperature drop along the surface of transparent contact probes, the area of thermal destruction is limited to the tissue in front of the probe, whereas along the entire surface of metal laser probes the tissue will be affected. The large difference between these temperature distributions should be respected during clinical application of the transparent contact probe and the metal laser probe.

To assess the feasibility of intra-arterial tissue ablation by Holmium:YSGG laser pulses (2.1 microns) in a noncontact mode, the transmission of the laser pulses through saline and blood was measured. The temporal interaction between the 500 microseconds laser pulse and saline at the fiber tip was investigated with time-resolved flash photography. The penetration depth in blood, and saline depended on the fiber output energy. In blood at 37 degrees C, the penetration depth varied from 1.2 to 2.1 mm for intensities of 3.1 to 12.4 J/mm2 per pulse, respectively, whereas its theoretical value for water is 0.33 mm, which is based on the measured absorption coefficient of 3.0 +/- 0.1/mm. The large penetration depth was due to the development of a transparent vapour cavity around the fiber tip. In saline, its maximum length was 4.7 mm. Its maximum width was 2.8 mm. The lifetime of the cavity was 450 microseconds. In blood, ablation of porcine aorta was feasible at a distance of 3 mm. Large fissures observed in adjacent tissue are likely to be caused by the expansion of the vapour cavity. We conclude that, due to a "Moses effect in the microsecond region," Holmium:YSGG tissue ablation is possible through at least 2.7 mm of blood.

Modified fiber tips are used for laser angioplasty of totally occluded peripheral arteries. It has not been established, however, to what extent the mechanism of action of various laser probes is optical, thermal, or mechanical. We examined transparant contact probes (hemispherical contact probes and ball-shaped fibers) and metal laser probes, coupled to a continuous-wave Nd-YAG laser. By using homogeneous thick porcine fatty tissue samples submerged in blood plasma, tissue penetration was measured in relation to the temperature of the probe and the axial force exerted on the tissue. By using 15 W, 1 s laser pulses, the surface of transparent contact probes had to be first contaminated by carbonized tissue particles to achieve tissue penetration. Penetration increased from 1 to 10 mm per pulse when axial force increased from 20 to 100 g. Metal probes had to be sufficiently insulated from the liquid environment by water vapour entrapped in a denatured protein layer to exceed the threshold temperature of 225 degrees C for tissue penetration. When axial force increased from 20 to 80 g at 10 W continuous exposure, the velocity of tissue penetration increased in the range from 1 to 4 mm/s. Tissue penetration by modified fiber tips is attributed to both remodeling and vaporization of tissue. With transparent contact probes, tissue is heated partly by direct light absorption and partly by a hot probe surface. Axially directed force is necessary to displace lateral non-ablated tissue and to overcome mechanical resistance. We conclude that mechanical dilation due to axial catherization force (Dotter effect) contributes substantially to tissue penetration by transparent contact probes.

Pulsed lasers are being promoted for laser angioplasty because of their capacity to ablate obstructions without producing adjacent thermal tissue injury. The implicit assumption that thermal injury to the artery is to be avoided was tested. Thermal lesions were produced in the iliac arteries and aorta of normal rabbits by a) electrical spark erosion, b) the metal laser probe, and c) continuous wave neodymium-yttrium aluminum garnet (Nd-YAG) laser energy through the sapphire contact probe. High-energy doses were used to induce substantial damage without perforating the vessel wall. Thermal lesions (n = 77) were compared with mechanical lesions (n = 22) induced by oversized balloon dilation. Medial necrosis was induced by all four injury methods. Provided no extravascular contrast was observed after the injury, all damaged segments were patent after 1 to 56 days. The progression of healing with myointimal proliferation was remarkably similar for all injuries. At 56 days, the neointima measured up to 370 microns. In conclusion, provided no perforation with contrast extravasation occurred, the normal rabbit artery recovered well from transmural thermal injury. The wall healing response is largely nonspecific.