Search

Pore-throat size is a very crucial factor controlling the reservoir quality and oiliness of tight sandstones, which primarily affects rock-properties such as permeability and drainage capillary pressure. However, the wide range of size makes it difficult to understand their distribution characteristics as well as the specific controls on reservoir quality and oiliness. In order to better understand about pore-throat size distribution, petrographic, scanning electron microscopy (SEM), pressure-controlled mercury injection (PMI), rate-controlled mercury injection (RMI), quantitative grain fluorescence (QGF) and environmental scanning electron microscopy (ESEM) investigations under laboratory pressure conditions were performed on a suite of tight reservoir from the fourth member of the Lower Cretaceous Quantou Formation (K 1 q 4 ) in the southern Songliao Basin, China. The sandstones in this study showed different types of pore structures: intergranular pores, dissolution pores, pores within clay aggregates and even some pores related to micro fractures. The pore-throat sizes vary from nano- to micro-scale. The PMI technique views the pore-throat size ranging from 0.001 μm to 63 μm and revealed that the pore-throats with radius larger than 1.0 μm are rare and the pore-throat size distribution curves show evident fluctuations. RMI measurements indicated that the pore size distribution characteristics of the samples with different porosity and permeability values look similar. The throat size and pore throat radius ratio distribution curves had however significant differences. The overall pore-throat size distribution of the K 1 q 4 tight sandstones was obtained with the combination of the PMI and RMI methods. The permeability is mainly contributed by a small part of larger pore-throats (less than 30%) and the ratio of the smaller pore-throats in the samples increases with decreasing permeability. Although smaller pore-throats have negligible contribution on reservoir flow potential, they are very significant for the reservoir storage capacity. The pore-throats with average radius larger than 1.0 μm mainly exist in reservoirs with permeability higher than 0.1mD. When the permeability is lower than 0.1mD, the sandstones are mainly dominated by pore-throats with average radius from 0.1 μm to 1.0 μm. The ratio of different sized pore-throats controls the permeability of the tight sandstone reservoirs in different ways. We suggest that splitting or organizing key parameters defining permeability systematically into different classes or functions can enhance the ability of formulating predictive models about permeability in tight sandstone reservoirs. The PMI combined with QGF analyses indicate that oil emplacement mainly occurred in the pore-throats with radius larger than about 0.25–0.3 μm. This result is supported by the remnant oil micro-occurrence evidence observed by SEM and ESEM. [ABSTRACT FROM AUTHOR]

Abstract This research is focused on the characteristics and origin of major authigenic minerals and the influences on the reservoir quality of the Permian Wutonggou Formation sandstones in the eastern slope of Fukang Sag, Junggar Basin, Western China. Authigenic cements were observed and described from thin sections, scanning electron microscopy, fluorescence, and cathodoluminescence. The elemental concentrations of the authigenic minerals were measured by electron probe microanalysis. Additional characterizations were obtained from O and C stable isotope ratios and from the homogenization temperature of aqueous fluid inclusions. The results show that the sandstones in the Wutonggou Formation are dominated by volcanic lithic fragments. Carbonates and laumontites are the major authigenic minerals in the study area. Authigenic quartz and kaolinite can also be observed. Two types of carbonate cements are identified. The first type is calcite with yellow fluorescent hydrocarbon inclusions. The carbon and oxygen isotopes in the calcites are highly C-depleted and O-depleted. The homogenization temperatures of the aqueous fluid inclusions in the calcite cements are higher than the highest paleogeotemperatures during the burial history. Combined with the presence of authigenic fibrous illites and the illitization of kaolinites, it is determined that the precipitation of the calcites is related to the upwelling of deep fluids and was impacted by the CO 2 from the thermal decarboxylation of organic matters during the middle-late Jurassic. The second type is ferroan calcite with blue fluorescent hydrocarbon inclusions and higher contents of Fe, Mn, Cr, and Mg than in the calcites. The ferroan calcites in the Beisantai uplift are rich in 13C (δ13C (V-PDB) values are +22.10‰ and +22.16‰). The precipitation of these ferroan calcites was impacted by the CO 2 from crude oil biodegradation after the late Jurassic. Two types of laumontites are identified. The first type is partially dissolved and is characterized by a high Ca/Na ratio and low Fe contents. The second type is hardly dissolved, has hydrocarbon inclusions with yellow and blue fluorescence, and is characterized by a low Ca/Na ratio and high Fe contents. The first type of laumontite was precipitated prior to hydrocarbon charging and the second type was formed after hydrocarbon charging and meteoric water leaching. The hydration of the volcanic debris provided the source materials for both types of laumontite. The authigenic quartz and kaolinite were formed by the alteration of feldspars, laumontites, and volcanic materials. The evolution of the reservoir properties was impacted by various degrees of cementation and dissolution; as a result, the reservoir quality in the Beisantai uplift was better than in the Shaqiu area. Highlights • Origin and formation time of calcite cements is determined under the context of multi-stage tectonic subsidence and uplift. • The precipitation of the ferrocalcites in Beisantai uplift was impacted by biodegradation of crude oil, which was firstly found in this area. • Multistage laumontite are precipitated in the study area. • The diagenetic paragenetic sequence and evolution of the reservoir properties are established in study area which experienced a multi-stage uplift and subsidence process. [ABSTRACT FROM AUTHOR]

The Eocene sandstones in the northern Dongying Sag, Bohai Bay Basin, China, are reservoirs for large accumulations of hydrocarbons. The sandstones are mainly lithic arkoses and feldspathic litharenites, texturally and compositionally immature. These sandstones have a wide range of porosity (0.4–37%) and permeability (0.004–6969 mD) and show an overall decrease in reservoir quality from 1500 m to 5000 m below sea level. The reduction in reservoir quality is a product of several digenetic processes; these include compaction, precipitation of dolomite and calcite in eodiagenetic stage; compaction, feldspar dissolution, precipitation of quartz cements and clays (kaolin and illite) and precipitation of ferrocalcite and ankerite in mesodiagenetic stage. Mineral distribution pattern and isotopic composition suggest carbonate cements in sandstones originate from sources outside the sandstones. Carbonate cementation, together with compaction reduced the sandstones’ porosity and permeability significantly. In a sandstone bed, marginal sandstones with distance to sandstone/mudstone interface less than one meter always have lower porosity than central sandstones. As burial depth exceeds 4000 m, marginal sandstones have very low porosities (<5%), indicating that thin sandstone beds (<2 m) were totally destroyed by cementation and compaction, and only thick sandstone beds (>2 m) can be potential effective reservoirs. Feldspar dissolution and precipitation of clays and quartz cements have little impact on absolute porosity. Mineral distribution pattern and quantitative data show that leached feldspars are the internal source of authigenic quartz and clays in sandstones, and the volume difference between feldspar secondary porosity and related authigenic cements is generally less than 0.25%. However, although there is little or no net import of matter to the sandstones, the pore architecture changes dramatically. Primary macropores are lost as clays and quartz precipitate while the proportion of microporosity increases, occurring mainly between clay crystals. The overall result is that permeability is significantly degraded. [ABSTRACT FROM AUTHOR]