Search

As a special kind of Bragg grating, phase-shifted fiber Bragg grating (PS-FBG) has attracted extensive attention because of its extremely narrow transmission window and excellent sensing performance. The main purpose of this manuscript is to discuss the PS-FBG with special sensing characteristics and explore the influence of different inscription technologies on the sensing characteristics of PS-FBG by comparing the existing inscription methods. The sensing characteristics, advantages and disadvantages of PS-FBG with different structures are analyzed. [ABSTRACT FROM AUTHOR]

Laser welding–brazing of 5A06 aluminum to Ti6Al4V titanium in a butt configuration was carried out to discuss the influences of welding parameters on dissimilar joint properties. The effects of laser offset, welding speed, and laser power on the spreading length of the molten aluminum liquid, interface fracture zone width (IFZW), fracture roughness, intermetallic compounds (IMCs) thickness, and tensile strength were also investigated. The microstructure and fracture of the joint were also studied. The results show that the tensile strength of the joint is not only influenced by the thickness and type of IMCs, but also influenced by the spreading ability of the aluminum liquid, the fracture area broken at the Ti/fusing zone (FZ) interface, and the relative area of the brittle and ductile fracture in FZ. A dissimilar butt joint with an IMC thickness of 2.79 μm was obtained by adjusting the laser offset, welding speed, and laser power to 500 μm, 11 mm/s and 1130 W, respectively. The maximum tensile strength of the joint was up to 183 MPa, which is equivalent to 83% of the tensile strength of the 5A06 aluminum alloy. [ABSTRACT FROM AUTHOR]

We demonstrated a fiber in-line Mach-Zehnder interferometer (MZI) coated with platinum (Pt) for the simultaneous measurement of strain and temperature. The sensor was fabricated by splicing a section of multimode fiber (MMF) between two single mode fibers (SMFs) and the Pt coating was prepared by iron sputtering technology. Fine interference fringes of over 20 dB with a compact size of 20 mm were achieved. The experimental results of the two different resonant dips showed strain sensitivities of −2.06 pm/με and −2.21 pm/με, as well as temperature sensitivities of 55.2 pm/°C and 53.4 pm/°C, respectively. Furthermore, it was found that the Pt coating can improve the strain sensitivity significantly, resulting in an increase of about 54.5%. In addition, the sensor has advantages of easy fabrication, low cost, and high sensitivity, showing great potential for the dual-parameter sensing of strain and temperature. [ABSTRACT FROM AUTHOR]