Search

The pursuit of an advanced functional coating that simultaneously combines high hardness, wear resistance, and superior electrical conductivity has remained an elusive goal in the field of copper alloy surface enhancement. Traditional solid solution alloying methods often lead to a significant increase in electron scattering, resulting in a notable reduction in electrical conductivity, making it challenging to achieve a balance between high hardness, wear resistance, and high conductivity. The key lies in identifying a suitable microstructure where dislocation motion is effectively hindered while minimizing the scattering of conductive electrons. In this study, a novel Cu-MoSi2 coating was successfully fabricated on a CuCrZr alloy surface using the coaxial powder feeding high-speed laser cladding technique, with the addition of 10–30% MoSi2 particles. The coating significantly enhances the hardness and wear resistance of the copper substrate while maintaining favorable electrical conductivity. As the quantity of MoSi2 particles increases, the coating's hardness and wear resistance gradually improve, with minimal variance in conductivity. Among the coatings, the Cu-30%MoSi2 coating stands out with the highest hardness (974.5 HV0.5) and the lowest wear amount (0.062 mg/km), approximately 15 times the hardness of the copper base material (65 HV0.5) and only 0.45% of the wear amount (13.71 mg/km). Additionally, the coating exhibits a resistivity of 0.173 × 10−6 Ω·m. The extraordinary hardness and wear resistance of these coatings can be attributed to the dispersion strengthening effect of MoxSiy particles, while the high electrical conductivity is due to the low silicon content dissolved into the copper from the released MoSi2 particles, as well as the rapid cooling rates associated with the high-speed laser cladding process. [ABSTRACT FROM AUTHOR]

A cold spray–laser cladding composite gradient coating (CLGC) was successfully formed on a Cu substrate. In comparison with traditional laser cladding gradient coatings (LGC), cold spraying the pre-set Ni-Cu alloy's intermediate transition layer not only mitigates the negative impacts due to the high reflectivity of the copper substrate but also helps to minimize the difference in the coefficients of thermal expansion (CTE) between the substrate and coating. This reduces the overall crack sensitivity and improves the cladding quality of the coating. Besides this, the uniform distribution of hard phases in CLGC, such as Ni11Si12 and Mo5Si3, greatly increases its microhardness compared to the Cu substrate, thus resulting in the value of 478.8 HV0.5 being approximately 8 times that of the Cu substrate. The friction coefficient of CLGC is lowered compared to both the Cu substrate and LGC with respective values of 0.28, 0.54, and 0.43, and its wear rate is only one-third of the Cu substrate's. These results suggest CLGC has excellent anti-wear properties. In addition, the wear mechanism was determined from the microscopic morphology and element distribution and was found to be oxidative and abrasive. This approach combines cold spraying and laser cladding to form a nickel-based gradient coating on a Cu substrate without cracks, holes, or other faults, thus improving the wear resistance of the Cu substrate and improving its usability. [ABSTRACT FROM AUTHOR]