Search

Analysis of measured in-cylinder pressure data provides various parameters that characterize engine combustion process. Advanced engine control technologies use cylinder pressure based combustion parameters for closed loop control. Four step signal processing (i) absolute pressure correction, (ii) crank angle position referencing, (iii) cycle averaging and (iv) filtering is typically applied to get sufficiently accurate cylinder pressure data for an engine cycle. This paper focuses on cycle averaging and filtering of in-cylinder pressure signal from a conventional compression ignition (CI) engine. Experiments are conducted at different engine load and compression ratios at 1500 rpm. The in-cylinder pressure trace of 2500 consecutive engine cycles is recorded and analyzed. Effect of in-cylinder pressure signal noise and cyclic variation on combustion analysis is investigated. A method based on standard deviation of pressure and pressure rise rate is used to find sufficient minimum number of engine cycles to be recorded for averaging to get reasonably accurate pressure data independent of cyclic variability. [ABSTRACT FROM AUTHOR]

Abstract: Several parameters derived from heat release analysis are used for combustion diagnostics and control in internal combustion engines. It is important to tune the input parameters used in heat release calculations, in order to get correct estimation of heat release rate. In this study, tuning of input parameters is carried out by using cumulative heat release calculations of cylinder pressure during motoring. This tuning procedure uses offline iterative processing of motoring in-cylinder pressure data. The tuned parameters obtained from this method can also be utilized for online analysis of combustion parameters. Input parameters used in these investigations are intake air temperature, intake air pressure, phasing between the acquired pressure and crank angle position, compression ratio and scaling factor of heat transfer coefficient. Effect of error in these input parameters on estimated combustion and performance parameters like IMEP, combustion phasing, combustion duration, heat release rate, and maximum mean gas temperature are evaluated. The relative importance of measurement error in input parameters and its maximum expected error in the final results is analyzed in a HCCI combustion engine. Results shows that measurement errors in phasing between pressure and crank angle position, compression ratio and inlet air pressure affect estimated combustion and performance parameters significantly. [Copyright &y& Elsevier]