Search

Pyrolysis represents one of the most convenient technologies for the chemical transformation of waste. The exposure to corrosion products and high temperatures does, however, require chemically resistant construction materials. This study was carried out to analyze the corrosion behavior of 1.4571 (AISI 316Ti) and 1.4305 (AISI 303) stainless steels machined with wire electric discharge machining (WEDM) in a pyrolysis environment. Different machining parameters were used for both materials tested to examine the influence of WEDM machining. The total testing time in the pyrolysis environment was 28 days, with the testing chamber being refilled 12 times. The surface topography was analyzed following the WEDM, cleaning, and corrosion test. The surface morphology and cross-section analyses were carried out using electron microscopy at all three stages of the process. An analysis of the chemical composition of the surfaces was carried out as well as of the pyrolysis environment to which the samples were exposed. It was established that the organic acids found in the pyrolysis chamber did not degrade the tested stainless steels to a meaningful degree. Minor fissures, that is, fine precipitated carbides, were observed on the surface of both the steel types and in their subsurface layer, as well as a significant presence of carbon. This presence was directly connected to the impurities found on the surface after the removal from the test furnace that were probably of a protective or passivation nature.

Wire electrical discharge machining is an unconventional machining technology that is crucial in many industries. The surface quality of the machined parts is carefully monitored, but the condition of the subsurface layer also plays a crucial role, especially in case of defects occurrence such as cracks or burnt cavities. The subsurface layer of individual materials is affected differently due to wire electrical discharge machining. For this reason, this study was carried out focusing on a detailed analysis of transmission electron microscope (TEM) lamella made of Ti-6Al-4V titanium alloy, AlZn6Mg2Cu aluminum alloy, pure molybdenum, Creusabro 4800 steel, and Hardox 400 steel. The attention was first of all paid to the concentration and distribution of individual elements in the recast layer and also in the base material, which was often affected by wire electrical discharge machining. Further, a diffraction analysis was performed for each TEM lamella in the adhesive area and in the base material area. In order to assess the macro-effects on the machined material, the topography analysis of the machined surfaces and the morphology analysis were performed using electron microscopy.