Search

In this study, ZrMgMo

In this study, Al-Cu-Li alloys were pre-strained to various plastic strains before ageing. The T1 (Al2CuLi) precipitates and dislocation density in various pre-strained Al-Cu-Li alloys were analyzed with transmission electron microscopy (TEM) and X-ray diffraction (XRD) technology respectively. The micro-yield strength (Micro-YS) of tested alloys was measured and the strengthening mechanism was discussed. It is found that the pre-strain increases the dislocation density, promotes the precipitation and inhibits the growth of T1 precipitates. The precipitation strengthening of T1 precipitates is higher than strain strghening of dislocations and it first increase then decrease whearas the strain strenthening continuously increase with pre-strain. The improvement in strength of Al-Cu-Li alloy caused by pre-straining is mainly due to strain strengthening rather than precipitation strengthening. Therefore, although pre-strain improves the macro-yield strength (Macro-YS) as well as the Micro-YS, excessive pre-strains are not conducive to the improvement of the Micro-YS. The pre-strain of 2% is a promising method to simultaneously improve the Micro-YS and Macro-YS of Al-Cu-Li alloys due to its synergistic improvement effect on precipitation strengthening and strain strengthening. Macro-YS and Micro-YS of pre-strained Al-Cu-Li alloys can be estimated with a simple strength mode. However, the larger error between the estimated and measured Micro-YS suggests that the accurate estimation of Micro-YS requires further to consider the adverse effect of mobile dislocations caused by pre-strain on the Micro-YS.

In this study, 5 wt.% nanodiamond (ND) reinforced 2024Al matrix composites (ND/2024Al) were fabricated with various ball milling processes. The microstructure, compressive yield strength (σyc) and coefficient of thermal expansion (CTE) of ND/2024Al composites were investigated. It is found that the addition of 5 wt.% NDs significantly increases the σyc and decreases the CTE of 2024Al. High energy ball milling further increases σyc and decreases CTEs of ND/2024Al composite due to it enhances the fine grain strengthening of α-Al matrix and the dispersion strengthening of NDs, decreases the thermal mismatch stress at the ND/α-Al matrix interface, and increases the constraint of NDs on α-Al. The composites fabricated by the combinations of ball milling speeds and times of (5−7) h×(200−250)rpm and 9 h×300 rpm have the highest σyc and the lowest CTE respectively. Considering the different influence of ball milling parameters on σyc and CTEs, a evaluation coefficient α = σ ycC ⋅ e k c C σ y c M ⋅ e k c M ⋅ C T E M C T E C is proposed to evaluate the synergistic influence of mechanical properties and CTEs on the dimensional stability of ND/2024Al composites. Large value of α may lead to high dimensional stability of material, hence the α can be used to determine the ball milling parameters.The ball milling process of 250−300 rpm ball milling speeds and 5−7 h ball milling times are recommended based on α, which causes a 95–100 % increase in σyc and a 30–35 % decrease in CTE compared with 2024Al alloy, respectively.

Lightweight Al

The microstructure, phase, alloying behavior, and oxidation behavior of the Co