Search

Phase transition behaviors of poly(N-isopropylacrylamide) nanogels with different compositions induced by (−)-epigallocatechin-3-gallate (EGCG) and ethyl gallate (EG) has been investigated systematically. Monodisperse poly(N-isopropylacrylamide-co-N-hydroxymethyl acrylamide) (P(NIPAM-co-NMAM)) and poly(N-isopropylacrylamide-co-2-hydroxyethyl methacrylate) (P(NIPAM-co-HEMA)) nanogels with different feeding monomer ratios were prepared by emulsion polymerization. P(NIPAM-co-NMAM) nanogels exhibit rapid isothermal phase transition behavior in EGCG solutions with low concentration (10−3 mol/L) in less than 10 minutes. The thermosensitive phase transition behaviors of nanogels are affected not only by the copolymerized monomers but also by the concentrations of EGCG and EG in aqueous solutions. Nanogels remain in a shrunken state and do not exhibit thermosensitive phase transition behaviors in EGCG solutions (≥5 mmol/L), whereas they display thermo-responsive phase transition behaviors in EG solutions. The volume phase transition temperature (VPTT) shifts to lower temperatures with increasing EG concentration. The diameters of P(NIPAM-co-NMAM) nanogels decrease with increasing EG concentration at temperatures between 29 and 33 °C. In contrast, the diameters of P(NIPAM-co-HEMA) nanogels increase with increasing EGCG concentration at temperatures between 37 and 45 °C. The results demonstrate the potential of nanogels for simple detection of EG and EGCG concentrations in aqueous solutions over a wide temperature range, and EGCG can serve as a signal for the burst-release of drugs from the P(NIPAM-co-NMAM)-based carriers at physiological temperature. [ABSTRACT FROM AUTHOR]

Oily sludge, as a critical hazardous waste, requires appropriate treatment for resource recovery and harmfulness reduction. Here, fast microwave-assisted pyrolysis (MAP) of oily sludge was conducted for oil removal and fuel production. The results indicated the priority of the fast MAP compared with the MAP under premixing mode, with the oil content in solid residues after pyrolysis reaching below 0.2%. The effects of pyrolysis temperature and time on product distribution and compositions were examined. In addition, pyrolysis kinetics can be well described using the Kissinger-Akahira-Sunose (KAS) and the Flynn-Wall-Ozawa (FWO) methods, with the activation energy being 169.7–319.1 kJ/mol in the feedstock conversional fraction range of 0.2–0.7. Subsequently, the pyrolysis residues were further treated by thermal plasma vitrification to immobilize the existing heavy metals. The amorphous phase and the glassy matrix were formed in the molten slags, resulting in bonding and, hence, immobilization of heavy metals. Operating parameters, including working current and melting time, were optimized to reduce the leaching concentrations of heavy metals, as well as to decrease their volatilization during vitrification. [ABSTRACT FROM AUTHOR]