Search

The combination of complementary measurement techniques has become a frequent approach to improve scientific knowledge. Pairing of the high lateral resolution scanning force microscopy (SFM) with the spectroscopic information accessible through scanning transmission soft x-ray microscopy (STXM) permits assessing physical and chemical material properties with high spatial resolution. We present progress from the NanoXAS instrument towards using an SFM probe as an x-ray detector for STXM measurements. Just by the variation of one parameter, the SFM probe can be utilised to detect either sample photo-emitted electrons or transmitted photons. This allows the use of a single probe to detect electrons, photons and physical forces of interest. We also show recent progress and demonstrate the current limitations of using a high aspect ratio coaxial SFM probe to detect photo-emitted electrons with very high lateral resolution. Novel probe designs are proposed to further progress in using an SFM probe as a STXM detector.

A combined x-ray transmission and scanning force microscope setup (NanoXAS) recently installed at a dedicated beamline of the Swiss Light Source combines complementary experimental techniques to access chemical and physical sample properties with nanometer scale resolution. While scanning force microscopy probes physical properties such as sample topography, local mechanical properties, adhesion, electric and magnetic properties on lateral scales even down to atomic resolution, scanning transmission x-ray microscopy offers direct access to the local chemical composition, electronic structure and magnetization. Here we present three studies which underline the advantages of complementary access to nanoscale properties in prototype thin film samples.

We studied atomic contact potential variations of Si(111)-7 x 7 by Kelvin probe force microscopy with the amplitude modulation technique at the second resonance of a silicon cantilever. Enhanced sensitivity due to the high mechanical quality factor in ultra-high vacuum enabled local contact potential difference (LCPD) measurements of individual adatoms. The contrast of the measured LCPD map became stronger by reducing the tip-sample distance, and the averaged LCPD value shifted to more negative. The short-range interaction, arising from the covalent bonding interactions, strongly affects the LCPD measurement. Theoretical calculations indicate that the amplitude modulation method has a higher sensitivity than the frequency modulation method in practical cases. The tip-sample distance dependence of LCPD was investigated by numerical calculations.

We have developed an optical cantilever deflection detector with a spot size <3 µm and fm Hz(-1/2) sensitivity over a>10 MHz bandwidth. In this work, we demonstrate its potential for detecting small-amplitude oscillations of various flexural and torsional oscillation modes of cantilevers. The high deflection sensitivity of the interferometer is particularly useful for detecting cantilever oscillations in aqueous solutions, enabling us to reach the thermal noise limit in scanning or atomic force microscopy experiments with stiff cantilevers. This has resulted in atomic-resolution images of solid-liquid interfaces and submolecular-resolution images of native membranes.

The resonance frequency and the excitation amplitude of a silicon cantilever have been measured as a function of distance to a cleaved KBr(001) surface with a low-temperature scanning force microscope (SFM) in ultrahigh vacuum. We identify two regimes of tip-sample distances. Above a site-dependent critical tip-sample distance reproducible data with low noise and no interaction-induced energy dissipation are measured. In this regime reproducible SFM images can be recorded. At closer tip-sample distances, above two distinct atomic sites, the frequency values jump between two limiting curves on a timescale of tens of milliseconds. Furthermore, additional energy dissipation occurs wherever jumps are observed. We attribute both phenomena to rarely occurring changes in the tip apex configuration which are affected by short-range interactions with the sample. Their respective magnitudes are related to each other. A specific candidate two-level system is also proposed.