Search

The long fiber length required for the amplification of bismuth-doped fiber (BDF) has hindered its practical application. In this paper, we propose and demonstrate a feasible method to improve the active absorption of bismuth active centers (BACs) by optimizing the drawing conditions, achieving a high gain with a short fiber length. The bismuth-doped phosphosilicate fiber (BPSF) preform was fabricated by the modified chemical vapor deposition (MCVD) process and drawn into fiber under nine different conditions. The results indicate that the active absorption of BACs increases as the drawing temperature increases and the drawing speed decreases within these drawing parameters. Meanwhile, the corresponding gain per unit length is improved. Furthermore, a maximum gain of 31.6 dB at 1350 nm with the >20 dB gain wavelength range of 1311-1401 nm was achieved in a double-pass double-pump configuration, using only 45 m BPSF. Meanwhile, the -3 dB bandwidth was 1328-1370 nm. The gain per unit length is 0.7 dB/m, which, to the best of our knowledge, is the highest gain per unit length reported for the BPSF.

Extending the gain bandwidth of L-band optical fiber amplifier has provoked a widespread interest. To date, achieving a high-efficiency extended L-band amplification remains a challenge. Here, we report a cladding-pumped Er/Yb co-doped alumino-phosphosilicate fiber, prepared by the modified chemical vapor deposition process. We demonstrate the efficiency of alumino-phosphosilicate glass for cladding-pumped Er/Yb co-doped fiber, with a gain per unit fiber length of 0.45 dB/m at 1625 nm and a gain ripple of ∼9.4 dB. For 0.8 W pump power, the fiber exhibits a 20 dB gain bandwidth covering 1575-1625 nm and 6.9 dB noise figure at 1625 nm. Additionally, the utilization of multi-mode laser diode enables further significant power savings and cost reduction. To the best of our knowledge, Er/Yb co-doped fiber in alumino-phosphosilicate glass is first proposed, with a cladding-pumped scheme for enhancing an extended L-band performance.

The 1.5-µm fiber laser is widely used in the fields of laser lidar, remote sensing, and gas monitoring because of its advantages of being eye-safe and exhibiting low atmospheric transmission loss. However, due to the ∼1-µm amplified spontaneous emission (ASE) of the Er/Yb co-doped fiber (EYDF), it is difficult to improve the laser power. Here, we simulated the effect of the Er 3+ concentration and the seed power on ∼1-µm ASE, and fabricated a large mode area EYDF by the modified chemical vapor deposition process. Additionally, a piece of ytterbium-doped fiber was introduced into the master oscillator power amplifier (MOPA) configuration to absorb the generated ∼1-µm ASE simultaneously. Experimental results show that an output power of 345 W with a slope efficiency of 43% at 1535 nm is obtained in an all-fiber configuration, profiting from effective suppression of ∼ 1-µm ASE. To the best of our knowledge, this is the highest output power available with an Er/Yb co-doped fiber from an all-fiber MOPA configuration.