Search

Measurement of plasma parameters during the ablation phase in the Z-pinch is crucial for investigating the dynamic behaviors. In this study, optical Thomson scattering was employed to measure the temperature and velocity of the ablation plasma in a double-wire Z-pinch. The scattering spectra profiles were fitted using a model that considered the velocity distribution. The experimental results revealed the energy evolution of ablation plasma, the establishment of the global magnetic field and the development of axial non-uniformities. The precursor plasma was found to play a key role in strengthening the global magnetic field. A resistive layer near the wire core with a size of 1.5 mm was observed in the ablation plasma after the precursor plasma column formed. The plasma underwent rapid heating in this layer, the electron temperature rises from 17 eV to 22 eV. Upon leaving this layer, electron the temperature is stable at around 22 eV. The radial distribution of the ablation rate increases and decreases, indicating the axial motion of the ablation plasma, which could be caused by the tilt motion of the stream and the secondary modulation of the natural wavelength. [ABSTRACT FROM AUTHOR]

The formation of precursor plasma and ablation dynamics of Al thin liner explosion are investigated in this manuscript. The size of 12 mm in diameter, 10 μm in thickness Al liners are exploded on the Qin-1 facility (about 450 ns, 450 kA). An axial laser shadowgraphy and interferometry platform is set up to observe the plasma dynamics inside the liner. To solve the problem that the inside plasma density of the liner cannot be absolutely calibrated due to the lack of a zero plasma density area, we have established a CW laser interference system using a streak camera which can trace the interference lines over time. Low-density (10−7−10−6 g cm−3) precursor plasma is generated from the interior wall and flows towards the center with a velocity of about 150–200 km s−1, thus forming a column with high electron density by accumulation. Simultaneously, a high-density plasma layer flows toward the center at about 10 km s−1. The electron density of the central plasma column rises up rapidly after the precursor reaches the center and achieves 2.5 × 1018 cm−3 at 280 ns after the current starts. To fully understand the process, we have used the resistive magnetohydrodynamic code FLASH to realize a simulation to study interior precursor dynamics. We compared these simulation results with our experiments. Finally, we measured the voltage for the whole process and derived the inductance change and effective current radius. We compared the simulated current density distribution with the experimental result which proves that a considerable amount of current flows through the center plasma column, making the effective radius of current become smaller over time. [ABSTRACT FROM AUTHOR]

Experiments are performed on the 'Qin-1' double pulse current generator at Xi'an Jiaotong University to study the effect of the prepulse current on the implosion dynamics of two-wire Z-pinches. An independent prepulse current with an adjustable time-delay (Tdelay) is introduced to preheat the wires before the start of the main pulse current. An estimation of the deposited energy and the areal density reconstructed from the interferogram suggest that the wires are partly vaporized with a gasification fraction of ∼67%. The prepulse preconditioning has a redistribution effect on the load mass, which determines the subsequent implosion process. The planar implosion of the two-wire load with a preset Tdelay ⩽ 450 ns can be divided into the two-layer phase and the merged implosion phase. The snowplow-like implosion is the main characteristic of the shot with a 1050 ns Tdelay. The ablation streams gradually disappear with the increasing Tdelay. The proportion of the mass that participates in implosion is increased as the preset Tdelay increases from 120 ns to 1050 ns. [ABSTRACT FROM AUTHOR]