Search

Background: Image-based computational models are widely used to determine atherosclerotic plaque stress/strain conditions and investigate their association with plaque progression and rupture. However, patient-specific vessel material properties are in general lacking in those models, limiting the accuracy of their stress/strain measurements. A noninvasive approach of combining in vivo 3D multi-contrast and Cine magnetic resonance imaging (MRI) and computational modeling was introduced to quantify patient-specific carotid plaque material properties for potential plaque model improvements. Vessel material property variation in patients, along vessel segment, and between baseline and follow up were investigated. Methods: In vivo 3D multi-contrast and Cine MRI carotid plaque data were acquired from 8 patients with follow-up (18 months) with written informed consent obtained. 3D thin-layer models and an established iterative procedure were used to determine parameter values of the Mooney-Rivlin models for the 81slices from 16 plaque samples. Effective Young’s Modulus (YM) values were calculated for comparison and analysis. Results: Average Effective Young’s Modulus (YM) and circumferential shrinkage rate (C-Shrink) value of the 81 slices was 411kPa and 5.62%, respectively. Slice YM value varied from 70 kPa (softest) to 1284 kPa (stiffest), a 1734% difference. Average slice YM values by vessel varied from 109 kPa (softest) to 922 kPa (stiffest), a 746% difference. Location-wise, the maximum slice YM variation rate within a vessel was 311% (149 kPa vs. 613 kPa). The average slice YM variation rate for the 16 vessels was 134%. The average variation of YM values for all patients from baseline to follow up was 61.0%. The range of the variation of YM values was [-28.4%, 215%]. For plaque progression study, YM at follow-up showed negative correlation with plaque progression measured by wall thickness increase (WTI) (r = -0.7764, p = 0.0235). Wall thickness at baseline correlated with WTI negatively, with r = -0.5253 (p = 0.1813). Plaque burden at baseline correlated with YM change between baseline and follow-up, with r = 0.5939 (p = 0.1205). Conclusion: In vivo carotid vessel material properties have large variations from patient to patient, along the diseased segment within a patient, and with time. The use of patient-specific, location specific and time-specific material properties in plaque models could potentially improve the accuracy of model stress/strain calculations. [ABSTRACT FROM AUTHOR]

The current study demonstrated that theasinensin A (TSA) had a potential to form the complex with hydrophobic Trp-containing dipeptides, and to reduce their membrane potential by artificial-lipid membrane taste sensor. At a 1:3 molar ratio of the 6 Trp-containing dipeptides together with TSA, we observed a significant chemical shift of the protons of the dipeptides (Δδ) to a high magnetic field, when analyzed using 1H-nuclear-magnetic resonance (NMR) spectroscopy. The Δδ values were correlated with the hydrophobicity (log P) of the dipeptides and significant correlations were obtained (P = 0.022, R2 = 0.77); e.g., Trp-Leu with the highest log P value of 1.623 among the tested dipeptides showed the highest Δδ value of 0.105 ppm for the H7 proton of Trp-Leu, while less chemical shifts were observed in theasinensin B and epigallocatechin-3-O-gallate. Diffusion-ordered NMR spectroscopy revealed that the diffusion coefficient of 3 mM of Trp-Leu (7.6 × 10−11 m2/s) at a pulse field gradient in the range 0.05–0.3 T/m decreased in the presence of 3 mM TSA (6.6 × 10−11 m2/s), suggesting that Trp-Leu forms a complex with TSA. Quantum mechanical calculations and rotating frame nuclear Overhauser effect-NMR spectroscopy provided configuration information on the geometry of the complex that Trp-Leu formed with TSA (1:1 complex) with a ΔG energy of –8.7 kJ/mol. A sensor analysis using artificial-lipid membranes demonstrated that the changes in membrane potential of 1 mM Trp-Leu (21.8 ± 1.3 mV) and Leu-Trp (5.3 ± 0.9 mV) were significantly (P < 0.001) reduced by 1 mM TSA (Trp-Leu, 13.1 ± 2.4 mV; Leu-Trp, 3.5 ± 0.5 mV; TSA alone, 0.2 ± 0.01 mV), indicating the effective suppression of hydrophobicity of dipeptides by TSA-formed complex. [ABSTRACT FROM AUTHOR]

Initiation of hair follicle (HF) is the first and most important stage of HF morphogenesis. However the precise molecular mechanism of initiation of hair follicle remains elusive. Meanwhile, in previous study, the more attentions had been paid to the function of genes, while the roles of non-coding RNAs (such as long noncoding RNA and microRNA) had not been described. Therefore, the roles of long noncoding RNA(LncRNA) and coding RNA in sheep skin during the initiation of sheep secondary HF were integrated and analyzed, by using strand-specific RNA sequencing (ssRNA-seq).A total of 192 significant differentially expressed genes were detected, including 67 up-regulated genes and 125 down-regulated genes between stage 0 and stage 1 of HF morphogenesis during HF initiation. Only Wnt2, FGF20 were just significant differentially expressed among Wnt, Shh, Notch and BMP signaling pathways. Further expression profile analysis of lncRNAs showed that 884 novel lncRNAs were discovered in sheep skin expression profiles. A total of 15 lncRNAs with significant differential expression were detected, 6 up-regulated and 9 down-regulated. Among of differentially expressed genes and LncRNA, XLOC002437 lncRNA and potential target gene COL6A6 were all significantly down-regulated in stage 1. Furthermore, by using RNAhybrid, XLOC005698 may be as a competing endogenous RNA ‘‘sponges” oar-miR-3955-5p activity. Gene Ontology and KEGG pathway analyses indicated that the significantly enriched pathway was peroxisome proliferator-activated receptors (PPARs) pathway (corrected P-value < 0.05), indicating that PPAR pathway is likely to play significant roles during the initiation of secondary HF.Results suggest that the key differentially expressed genes and LncRNAs may be considered as potential candidate genes for further study on the molecular mechanisms of HF initiation, as well as supplying some potential values for understanding human hair disorders. [ABSTRACT FROM AUTHOR]

The efficacy of an inactivated foot-and-mouth disease (FMD) vaccine is mainly dependent on the integrity of the foot-and-mouth disease virus (FMDV) particles. At present, the standard method to quantify the active component, the 146S antigen, of FMD vaccines is sucrose density gradient (SDG) analysis. However, this method is highly operator dependent and difficult to automate. In contrast, the enzyme-linked immunosorbent assay (ELISA) is a time-saving technique that provides greater simplicity and sensitivity. To establish a valid method to detect and quantify the 146S antigen of a serotype O FMD vaccine, a double-antibody sandwich (DAS) ELISA was compared with an SDG analysis. The DAS ELISA was highly correlated with the SDG method (R2 = 0.9215, P<0.01). In contrast to the SDG method, the DAS ELISA was rapid, robust, repeatable and highly sensitive, with a minimum quantification limit of 0.06 μg/mL. This method can be used to determine the effective antigen yields in inactivated vaccines and thus represents an alternative for assessing the potency of FMD vaccines in vitro. But it still needs to be prospectively validated by analyzing a new vaccine preparation and determining the proper protective dose followed by an in vivo vaccination-challenge study to confirm the ELISA findings. [ABSTRACT FROM AUTHOR]