Search

Multiaxial testing in composites may generate failure modes which are more representative of what occurs in a real structure submitted to complex loading conditions. However, some of its main handicaps include the need for special facilities, the correct design of the experiments, and the challenging interpretation of the results. The framework of this research is based on a triaxial testing machine with six actuators which is able to apply simultaneous and synchronized axial loads in the three space directions. Then, the aim was to design from a numerical point of view a triaxial experiment adapted to this equipment. The methodology proposed could allow for an adequate characterization of the triaxial response of a polymer-based composite with apparent isotropic behaviour in the testing directions. The finite element method (FEM) is applied in order to define the geometry of the triaxial specimen. The design pursues to achieve homogeneous stress and strain states in the triaxially loaded region, which should be accessible for direct measurement of the strains. Moreover, a fixing system is proposed for experimentally reproducing the desired boundary conditions imposed on the numerical simulations. The procedure to determine the full strain tensor in the triaxially loaded region is described analytically and with the help of FEM virtual testing. The hydrostatic component and the deviatoric part of the strain tensor are proposed for estimating the susceptibility of the polymer-based composite to fail due to the triaxial strain state imposed. Then, the loading scenarios that cause higher values of the deviatoric components in the triaxially loaded region are considered to be more prone to damage the region of interest. Nevertheless, the experimental failure is expected to be produced in the arms of the specimen which are uniaxially loaded, since in all of the loading cases the simulations show higher levels of stress concentration out of the triaxially loaded region. Thus, although the triaxial strength could not be accurately determined by the proposed tests, they can be utilized for observing the triaxial response before failure. [ABSTRACT FROM AUTHOR]

The heterogeneity and anisotropy of fibre-reinforced polymer matrix composites results in a highly complex mechanical response and failure under multiaxial loading states. Among the different biaxial testing techniques, tests with cruciform specimens have been a preferred option, although nowadays, they continue to raise a lack of consensus. It is therefore necessary to review the state of the art of this testing methodology applied to fibre-reinforced polymers. In this context, aspects such as the specific constituents, the geometric design of the specimen or the application of different tensile/compressive load ratios must be analysed in detail before being able to establish a suitable testing procedure. In addition, the most significant results obtained in terms of the analytical, numerical and experimental analyses of the biaxial tests with cruciform specimens are collected. Finally, significant modifications proposed in literature are detailed, which can lead to variants or adaptations of the tests with cruciform specimens, increasing their scope. [ABSTRACT FROM AUTHOR]