Search

The need for high quality machining of composite materials is rising due to the increased utilisation of these materials across several applications. This paper presents experimental findings of orthogonal cutting of unidirectional glass fibre reinforced plastic (UD-GFRP) composites using HSS single-point cutting tools. Key process indicators including cutting forces, chip formation and surface integrity were evaluated. Full factorial design is employed with fibre orientation, depth of cut, cutting speed and rake angle as process control variables. Fibre orientation and depth of cut were found to be the most significant factors affecting the investigated responses. Lower cutting forces and better surface quality were obtained at 0o fibre orientation and lower depth of cut. Cutting at 45o fibre orientation generated extremely damaged surfaces with relatively high average surface roughness values and should be avoided in practical applications.

Power consumed in metal cutting is typically converted into heat near the cutting tool edge. Cutting fluids are then provided to a cutting zone in order to improve the tribological characteristics of machining processes and to dissipate the generated heat. The use of conventional cutting fluids however has lately been questioned due to the adverse impact on the environment and human health. Therefore, trends are directed to various alternatives such as vegetable oils (VOs). VOs offer a combination of good biodegradability and high lubricity, eco-friendly and compatibility with additives, low toxicity and volatility, high flash points and high viscosity indices. This paper details preliminary experimental results when turning Ti-6Al-4V. The impact of VO-based cutting fluids, cutting tool materials and working conditions were investigated. Two sets of experimental plans were designed comprising 25 and 27 tests with analysis of variance (ANOVA) employed to evaluate the effect of process variables on Ra and tool flank wear. In general, surface roughness Ra ranged between 0.56μm and 1.81μm and statistical analysis showed that the main contributing factor for Ra is feed rate having a high Percentage Contribution Ratio (PCR) of 94.4%. Noticeable increase in tool tip flank wear was recorded when higher cutting speeds were used.