Search

We present a novel approach to determine the constitutive properties of metals under large plastic strains and strain rates that otherwise are difficult to access using conventional materials testing methods. The approach exploits large-strain plastic flow past a sharp wedge, coupled with high-speed photography and image velocimetry to capture the underlying plastic flow dynamics. The inverse problem of estimating material parameters from the flow field is solved using an iterative optimization procedure that minimizes the gap between internal and external plastic work. A major advantage of the method is that it neither makes any assumptions about the flow nor requires computational simulations. To counter the problem of non-unique parameter estimates, we propose a parameterization scheme that takes advantage of the functional form of the constitutive model and reformulates the problem into a more tractable form to identify plasticity parameters uniquely. We present studies to illustrate the principle of the method with two materials with widely different plastic flow characteristics: copper (strain hardening) and a lead-free solder alloy (rate sensitive and deformation history dependent). The results demonstrate the efficacy of the method in reliably determining the material parameters under high strain/strain rate conditions of relevance to a range of practical engineering problems. [ABSTRACT FROM AUTHOR]

Shear banding, or localization of intense strains along narrow bands, is a plastic instability in solids with important implications for material failure in a wide range of materials and across length scales. In this article, we report on a series of experiments on the nucleation of single isolated shear bands in three model alloys. Nucleation kinetics of isolated bands and characteristic stresses are studied using high-speed in situ imaging and parallel force measurements. The results demonstrate the existence of a critical shear stress required for band nucleation. The nucleation stress bears little dependence on the normal stress and is proportional to the shear modulus. These properties are quite akin to those governing the onset of dislocation slip in crystalline solids. A change in the flow mode from shear banding to homogeneous plastic flow occurs at stress levels below the nucleation stress. Phase diagrams delineating the strain, strain rate and temperature domains where these two contrasting flow modes occur are presented. Our work enables interpretation of shear band nucleation as a crystal lattice instability due to (stress-assisted) breakdown of dislocation barriers, with quantitative experimental support in terms of stresses and the activation energy. [ABSTRACT FROM AUTHOR]

Shear banding is a plastic flow instability with highly undesirable consequences for metals processing. While band characteristics have been well studied, general methods to control shear bands are presently lacking. Here, we use high-speed imaging and micro-marker analysis of flow in cutting to reveal the common fundamental mechanism underlying shear banding in metals. The flow unfolds in two distinct phases: an initiation phase followed by a viscous sliding phase in which most of the straining occurs. We show that the second sliding phase is well described by a simple model of two identical fluids being sheared across their interface. The equivalent shear band viscosity computed by fitting the model to experimental displacement profiles is very close in value to typical liquid metal viscosities. The observation of similar displacement profiles across different metals shows that specific microstructure details do not affect the second phase. This also suggests that the principal role of the initiation phase is to generate a weak interface that is susceptible to localized deformation. Importantly, by constraining the sliding phase, we demonstrate a material-agnostic method--passive geometric flow control--that effects complete band suppression in systems which otherwise fail via shear banding. [ABSTRACT FROM AUTHOR]