Search

Abstract Background To evaluate by means of profilometric analysis and scanning electronic microscope (SEM) the effects on enamel surfaces of oscillating mechanical systems for interproximal enamel reduction (IPR). Fifteen complete (Group 1) oscillating IPR sequence and 15 single metallic strips (Group 2) for active IPR phase of 0.2 mm were selected and tested on 30 freshly extracted teeth by means of tribological tests with alternative dry-sliding motion (Linear Reciprocating Tribometer, C.S.M. Instruments, Peseaux, Switzerland). Enamel surface roughness and waviness measurements were assessed by contact probe surface profiler (TalySurf CLI 2000; Taylor Hobson, Leicester, UK) and a TayMap software for the 3D analysis. Statistical analysis was performed with independent samples t-test. Significance was established at the P

Abstract Background To evaluate load and stress distribution on Delaire facemask (FM) during maxillary protraction in class III growing patients by means of finite element analysis (FEA). A three-dimensional geometry of a Delaire FM was reconstructed from the original CAD 3D prototype, using software package (ANSYS 5.7). FM presented forehead and chin supports and stainless steel framework characterized by two lateral vertical bars connected to a crossbar with two pawls for elastic attachment. Two traction intensities (7.8 and 9.8 N) were applied on the FM pawls along three different downward inclined directions with respect to the occlusal plane (0°, 30°, or 50°, respectively). Resulting stresses and deformations were then tested through the von Mises yield criterion in order to underline the FM wear performance. Results The analysis showed that higher stresses and deformations are mostly related to axial forces of 9.8 N rather than 7.8 N. Stresses also progressively increased with increasing downward force inclinations (0°, 30°, and 50° with respect to the occlusal plane). The overall tensions were inferior to the limit of the elastic behavior (yield point) characterizing the material they are applied on. Thus, the FM structure absorbed the load applied with an elastic deformation of the lateral and horizontal bars. Conclusions Resulting stresses and deformations were directly proportional to protraction load amounts and to increasing downward inclination of forces. In all tested conditions, protraction forces were not able to determine plastic deformation on FM structure compromising its performance and efficiency.