Search

Land surface albedo directly determines the distribution of radiant energy between the surface and the atmosphere, and it is a key parameter affecting the energy balance on the land surface. However, the spatiotemporal dynamics of land surface albedo and associated influencing factors in the Qilian Mountains (QM) have been rarely reported. By using the long-time series data products of MODIS shortwave albedo, normalized difference vegetation index (NDVI), and snow cover with a spatial resolution of 0.05° from 2001 to 2020, this paper analyzes the temporal and spatial variations of land surface albedo in the QM over the past 20 years and its influencing factors. The analysis results show that the multi-year average surface albedo in the QM has obvious differences in spatial distribution: it increases with the altitude, and it is high in the west (at the west of 98° E) and low in the east. Meanwhile, the surface albedo has different distribution characteristics in different seasons: the spatial distribution of surface albedo is similar in spring and autumn; the areas with a high surface albedo in summer are significantly fewer than those in other seasons. Besides, in the past 20 years, the annual average surface albedo has shown a weak growth trend in the QM, with a change rate of 5 × 10−3/10a, and the minimum and maximum values were reached in 2001 and 2019, respectively. In addition, the annual variation of the surface albedo in the QM showed a "U" shape, with the largest variation in January and the smallest variation in August. The annual variation of surface albedo is significantly positively correlated with snow cover (r = 0.96) and significantly negatively correlated with NDVI (r = −0.91). Moreover, the interannual variation of the surface albedo in the QM is closely related to land surface cover and is greatly affected by snow cover. Spatially, the annual variation of surface albedo in most areas of the QM is dominated by the change of snow cover, and the increase of surface albedo in the middle area is consistent with the increase of snow cover, while the decrease of albedo in the edge area is related to the improvement of vegetation cover. The results of this study provide a scientific basis for studying the climate and environmental changes caused by changes in the surface of the QM and making ecological environment restoration strategies. [ABSTRACT FROM AUTHOR]

Mountainous regions experience complex phenological behavior along climatic, vegetational and topographic gradients. In this paper, we use a MODIS time series of the Normalized Difference Vegetation Index (NDVI) to understand the causes of variations in spring and autumn timing from 2000 to 2015, for a landscape renowned for its biological diversity. By filtering for cover type, topography and disturbance history, we achieved an improved understanding of the effects of seasonal weather variation on land surface phenology (LSP). Elevational effects were greatest in spring and were more important than site moisture effects. The spring and autumn NDVI of deciduous forests were found to increase in response to antecedent warm temperatures, with evidence of possible cross-seasonal lag effects, including possible accelerated green-up after cold Januarys and early brown-down following warm springs. Areas that were disturbed by the hemlock woolly adelgid and a severe tornado showed a weaker sensitivity to cross-year temperature and precipitation variation, while low severity wildland fire had no discernable effect. Use of ancillary datasets to filter for disturbance and vegetation type improves our understanding of vegetation’s phenological responsiveness to climate dynamics across complex environmental gradients. [ABSTRACT FROM AUTHOR]

The aim of this paper is to assess the latest version of the MODIS LAI/FPAR product (MOD15A2H), namely Collection 6 (C6). We comprehensively evaluate this product through three approaches: validation with field measurements, intercomparison with other LAI/FPAR products and comparison with climate variables. Comparisons between ground measurements and C6, as well as C5 LAI/FPAR indicate: (1) MODIS LAI is closer to true LAI than effective LAI; (2) the C6 product is considerably better than C5 with RMSE decreasing from 0.80 down to 0.66; (3) both C5 and C6 products overestimate FPAR over sparsely-vegetated areas. Intercomparisons with three existing global LAI/FPAR products (GLASS, CYCLOPES and GEOV1) are carried out at site, continental and global scales. MODIS and GLASS (CYCLOPES and GEOV1) agree better with each other. This is expected because the surface reflectances, from which these products were derived, were obtained from the same instrument. Considering all biome types, the RMSE of LAI (FPAR) derived from any two products ranges between 0.36 (0.05) and 0.56 (0.09). Temporal comparisons over seven sites for the 2001-2004 period indicate that all products properly capture the seasonality in different biomes, except evergreen broadleaf forests, where infrequent observations due to cloud contamination induce unrealistic variations. Thirteen years of C6 LAI, temperature and precipitation time series data are used to assess the degree of correspondence between their variations. The statistically-significant associations between C6 LAI and climate variables indicate that C6 LAI has the potential to provide reliable biophysical information about the land surface when diagnosing climate-driven vegetation responses. [ABSTRACT FROM AUTHOR]

The sea ice cover is changing rapidly in polar regions, and sea ice products with high temporal and spatial resolution are of great importance in studying global climate change and navigation. In this paper, an ice map generation model based on Moderate-Resolution Imaging Spectroradiometer (MODIS) reflectance bands is constructed to obtain sea ice data with a high temporal and spatial resolution. By constructing a training sample library and using a multi-feature fusion machine learning algorithm for model classification, the high-accuracy recognition of ice and cloud regions is achieved. The first product provided by this algorithm is a near real-time single-scene sea ice presence map. Compared with the photo-interpreted ground truth, the verification shows that the algorithm can obtain a higher recognition accuracy for ice, clouds, and water, and the accuracy exceeds 98%. The second product is a daily and weekly clear sky map, which provides synthetic ice presence maps for one day or seven consecutive days. A filtering method based on cloud motion is used to make the product more accurate. The third product is a weekly fusion of clear sky optical images. In a comparison with the Advanced Microwave Scanning Radiometer 2 (AMSR2) sea ice concentration products performed in August 2019 and September 2020, these composite images showed spatial consistency over time, suggesting that they can be used in many scientific and practical applications in the future. [ABSTRACT FROM AUTHOR]

This is an update of Sobrino et al.'s paper, published in January 2020, which extends the calculation of the Earth's surface temperature to the period 2003–2019 and uses the new version 2019.0 for the sea surface temperature product MODIS, which is available from 15 January 2020 and replaces version 2014.0. The land surface temperature was estimated from the MCD11C1 product for the same period. The results corroborate the temperature anomalies retrieved from climate models and improve the comparison with global annual air temperatures estimated by the NOAA's National Climatic Data Center (NOAA-NCDC), with a correlation coefficient of 0.96. In addition, a trend of 0.021 ± 0.001 °C/year increase was found for the Earth's surface temperature in this 17-year period. [ABSTRACT FROM AUTHOR]

Cloud top height (CTH) is an essential pareter for the general circulation model in understanding the impact of clouds on the Earth's radiation budget and global climate change. This paper compares the CTH products, derived from the Moderate Resolution Imaging Spectroradiometer (MODIS), onboard the Aqua and Terra satellites with ground-based Ka band radar data in Beijing from 2014 to 2017. The aim was to investigate the data accuracy and the difference in CTH measurements between passive satellite data and active ground-based radar data. The results show that MODIS, on average, underestimates CTH relative to radar by −1.08 ± 2.48 km, but with a median difference of −0.65 km and about 48% of differences are within 1 km. Statistically, MODIS CTHs which are greater than 6 km show lower discrepancy to radar CTH than those of MODIS CTHs less than 4 km. The CTH difference is independent of cloud fraction and cloud layer. It shows strong dependence on cloud depth, decreasing as cloud depth increases. There is a tendency for MODIS to underestimate high thin clouds but overestimate low thin clouds relative to radar. Total ozone, SO2, CO, NO2, aerosol PM10, total water vapor and temperature inversion show unobvious influences in the CTH discrepancy. It is shown that the MODIS CO2-slicing technique performs much better than IRW (infrared window) technique when cloud layer is higher than 2 km. The average difference calculated from all comparisons by CO2-slicing technique and IRW technique is 0.09 ± 1.58 km, and −2.20 ± 2.73 km, respectively. [ABSTRACT FROM AUTHOR]

As an essential climate variable (ECV), land surface albedo plays an important role in the Earth surface radiation budget and regional or global climate change. The Tibetan Plateau (TP) is a sensitive environment to climate change, and understanding its albedo seasonal and inter-annual variations is thus important to help capture the climate change rules. In this paper, we analyzed the large-scale spatial patterns, temporal trends, and seasonal variability of land surface albedo overall the TP, based on the moderate resolution imaging spectroradiometer (MODIS) MCD43 albedo products from 2001 to 2019. Specifically, we assessed the correlations between the albedo anomaly and the anomalies of normalized difference vegetation index (NDVI), the fraction of snow cover (snow cover), and land surface temperature (LST). The results show that there are larger albedo variations distributed in the mountainous terrain of the TP. Approximately 10.06% of the land surface is identified to have been influenced by the significant albedo variation from the year 2001 to 2019. The yearly averaged albedo was decreased significantly at a rate of 0.0007 (Sen's slope) over the TP. Additionally, the yearly average snow cover was decreased at a rate of 0.0756. However, the yearly average NDVI and LST were increased with slopes of 0.0004 and 0.0253 over the TP, respectively. The relative radiative forcing (RRF) caused by the land cover change (LCC) is larger than that caused by gradual albedo variation in steady land cover types. Overall, the RRF due to gradual albedo variation varied from 0.0005 to 0.0170 W/m2, and the RRF due to LCC variation varied from 0.0037 to 0.0243 W/m2 during the years 2001 to 2019. The positive RRF caused by gradual albedo variation or the LCC can strengthen the warming effects in the TP. The impact of the gradual albedo variations occurring in the steady land cover types was very low between 2001 and 2019 because the time series was short, and it therefore cannot be neglected when examining radiative forcing for a long time series regarding climate change. [ABSTRACT FROM AUTHOR]

Particulate matter (PM) has a substantial influence on the environment, climate change and public health. Due to the limited spatial coverage of a ground-level PM2.5 monitoring system, the ground-based PM2.5 concentration measurement is insufficient in many circumstances. In this paper, a Specific Particle Swarm Extinction Mass Conversion Algorithm (SPSEMCA) using remotely sensed data is introduced. Ground-level observed PM2.5, planetary boundary layer height (PBLH) and relative humidity (RH) reanalyzed by the European Centre for Medium-Range Weather Forecasts (ECMWF) and aerosol optical depth (AOD), fine-mode fraction (FMF), particle size distribution, and refractive indices from AERONET (Aerosol Robotic Network) of the Beijing area in 2015 were used to establish this algorithm, and the same datasets for 2016 were used to test the performance of the SPSEMCA. The SPSEMCA involves four steps to obtain PM2.5 values from AOD datasets, and every step has certain advantages: (I) In the particle correction, we use η2.5 (the extinction fraction caused by particles with a diameter less than 2.5 μm) to make an accurate assimilation of AOD2.5, which is contributed to by the specific particle swarm PM2.5. (II) In the vertical correction, we compare the performance of PBLHc retrieved by satellite Lidar CALIPSO data and PBLHe reanalysis by ECMWF. Then, PBLHc is used to make a systematic correction for PBLHe. (III) For extinction to volume conversion, the relative humidity and the FMF are used together to assimilate the AVEC (averaged volume extinction coefficient, μm2/μm3). (IV) PM2.5 measured by ground-based air quality stations are used as the dry mass concentration when calculating the AMV (averaged mass volume, cm3/g) in humidity correction, that will avoid the uncertainties derived from the estimation of the particulate matter density ρ. (V) Multi-Angle Implementation of Atmospheric Correction (MAIAC) 1 km × 1 km AOD was used to retrieve high resolution PM2.5, and a LookUP Table-based Spectral Deconvolution Algorithm (LUT-SDA) FMF was used to avoid the large uncertainties caused by the MODIS FMF product. The validation of PM2.5 from the SPSEMCA algorithm to the AERONET observation data and MODIS monitoring data achieved acceptable results, R = 0.70, RMSE (root mean square error) = 58.75 μg/m3 for AERONET data, R = 0.75, RMSE = 43.38 μg/m3 for MODIS data, respectively. Furthermore, the trend of the temporal and spatial distribution of Beijing was revealed. [ABSTRACT FROM AUTHOR]