Search

The sky-radiometer/sun-photometer is the most widely used instrument for obtaining aerosol optical depth (AOD) or aerosol optical properties worldwide. Due to the existence of field of view (FOV, 1°), the radiation received by the sky-radiometer includes the forward scattering in addition to direct solar irradiance. This leads to more diffuse light errors of retrieved AODs, especially for shorter wavelength and heavily polluted weather conditions. Using simulation data of three typical aerosol particles (dust, soot, water-soluble), we first verified the accuracy of the Monte Carlo method for calculating the forward scattering effect. Based on the sky-radiometer data collected in Xi’an (2015–2020) where heavy pollution weather is common, the relative errors and correction factors of the AOD were obtained under different conditions, including various short wavelengths (≤400 nm), solar zenith angles (SZAs) and AODs. Our analysis indicates the close dependence of AOD correction factors on wavelength, SZA, AOD and the optical properties of aerosol particles. The mean relative error in Xi’an increases with the decrease of wavelength (~16.1% at 315 nm) and decreases first and then increases with the increase of the SZA. The relative errors caused by forward scattering can exceed 10% when the AOD is greater than 1 and 25% when the AOD is larger than 2 in the ultraviolet (UV) band. The errors with a wavelength greater than 400 nm and an AOD below 1.0 can be within 5%, which can be ignored. The correlation coefficients of AODs before and after a correction from 315 nm to 400 nm are greater than 0.96, which basically increase with the increase of the wavelength. This indicates that the significance of the forward scattering effect in the Xi’an area with heavy pollution cannot be ignored for short wavelengths. However, such effect is negligible at the longer wavelengths and lower AODs (

A macro-vertical structure is closely related to weather evolution and the energy budget balance of the atmospheric system of the Earth. In this study, radiosonde data were used to identify a cloud vertical structure (CVS) using the adjusted relative humidity threshold method. To evaluate the reliability and stability of this method, the results obtained based on the spatiotemporal matching criteria established in this study were compared with Ka-band millimetre-wave cloud radar (MMCR) observation data. This comparison showed that both devices exhibit high consistency in low-level cloud detection. With the increase in the cloud height, the frequency of the cloud appearance detection by the radiosonde became higher than that by the MMCR. In spring, the results of the CVS detection by the two devices were in good agreement. Specifically, the determination coefficients of the modified degrees of freedom (adjusted R-square) of the cloud base height (CBH) and cloud top height (CTH) detected by the two devices were 0.934 and 0.879, respectively. The horizontal drift of the radiosonde was the smallest in summer, and the adj. R-square values of the CBH and CTH were 0.814 and 0.852, respectively. The CVS observation results by the radiosonde and the MMCR were significantly different in autumn (the adj. R-Square values of the CBH and CTH were 0.715 and 0.629, respectively). In winter, the adj. R-Square values of the CBH and CTH observed by the radiosonde and the MMCR were 0.958 and 0.710, respectively. The statistics and analysis of the results of the distribution characteristics of the CVSs using radiosonde data from 2019 to 2021 from Xi’an showed that the average CTH and CBH were at 7–10 km and 3–5 km, respectively. The frequencies of the cloud absence, rainfall, and two- and three-layer clouds were the highest in the winter (34.36%), autumn (12.99%), and summer, respectively.

Cloud droplets size distribution (DSD) is one of the significant characteristics for liquid clouds. It plays an important role for the aerosol–droplet–cloud mechanism and variation in cloud microphysics. However, the minuscule sampling space is insufficient for the observation of whole DSD when using high-magnification optical systems. In this paper, we propose an observation method for cloud droplets ranging from 2 to 16 μm, by which the balance relationship between sampling space and optical magnification is realized. The method combines an in-line digital holographic interferometer (DHI) with the optical magnification of 5.89× and spatial stitching technique. The minimum size in DSD is extended to 2 μm, which improves the integrity of size distribution. Simultaneously, the stability of DSD is enhanced by increasing the tenfold sampling volume of cloud droplets. The comparative experiment between the in-line DHI and fog monitor demonstrates that the DSD obtained by this method is reliable, which can be used for the analysis of microphysical parameters. In the Beijing Aerosol and Cloud Interaction Chamber (BACIC), the observation results show that the size of cloud droplets follows the Gamma distribution, which is consistent with the theoretical DSD. The results of cloud microphysical parameters indicate that each pair of parameters has a positive correlation, and then the validity of observation method is confirmed. Additionally, the high-concentration aerosol condition significantly mitigates the effect of random turbulence and enhances the robustness of the microphysical parameter data.

In order to investigate the aerosol variability over the southwest region of Slovenia, an ultraviolet scanning elastic backscatter LiDAR was utilized to make the vertical scan for atmospheric probing. With the assumption of horizontal atmospheric homogeneity, aerosol optical variables were retrieved from the horizontal pixel data points of two-dimensional range-height-indicator (RHI) diagrams by using a multiangle retrieval method, in which optical depth is defined as the slope of the resulting linear function when height is kept constant. To make the data retrieval feasible and precise, a series of key procedures complemented the data processing, including construction of the RHI diagram, correction of Rayleigh scattering, assessment of horizontal atmospheric homogeneity and retrieval of aerosol optical variables. The measurement example demonstrated the feasibility of the ultraviolet scanning elastic backscatter LiDAR in the applications of the retrieval of aerosol extinction and determination of the atmospheric boundary layer height. Three months’ data combined with the modeling of air flow trajectories using Hybrid Single Particle Lagrangian Integrated Trajectory Model were analyzed to investigate aerosol variability. The average value of aerosol extinction with the presence of land-based air masses from the European continent was found to be two-times larger than that influenced by marine aerosols from the Mediterranean or Adriatic Sea.

The use of Raman and high-spectral lidars enables measurements of a stratospheric aerosol extinction profile independent of backscatter, and a multi-wavelength (MW) lidar can obtain additional information that can aid in retrieving the microphysical characteristics of the sampled aerosol. The inversion method for retrieving aerosol particle size distributions and microphysical particle parameters from MW lidar data was studied. An inversion algorithm for retrieving aerosol particle size distributions based on the regularization method was established. Based on the inversion of regularization, the inversion method was optimized by choosing the base function closest to the aerosol distribution. The logarithmic normal distribution function was selected over the triangle function as the base function for the inversion. The averaging procedure was carried out for three main types of aerosol. The 1% averaging result near the minimum of the discrepancy gave the best estimate of the particle parameters. The accuracy and stabilization of the optimized algorithm for microphysical parameters were tested by scores of aerosol size distributions. The systematic effects and random errors impacting the inversion were also considered, and the algorithm was tested by the data, showing 10% systematic error and 15% random error. At the same time, the reliability of the proposed algorithm was also verified by using the aerosol particle size distribution data of the aircraft. The inversion results showed that the algorithm was reliable in retrieving the aerosol particle size distributions at vertical heights using lidar data.

All-day atmospheric water vapor content measurements determined by Raman lidar and a sunphotometer were combined to investigate the all-day variation characteristics in the water vapor distribution in Xi’an, China (34.233°N, 108.911°E). To enhance the daytime lidar performance, the wavelet threshold de-noising method is used to filter out the strong solar background light, and effective denoised results are demonstrated with the following optimization: wavelet sym6, the improved threshold function, and the improved threshold selection. The denoised system signal-to-noise ratio (SNR) for the water vapor daytime measurement is validated, with an enhancement of ~3.4 times up to a height of 3 km compared to that of the original signal. The time series of the atmospheric water vapor mixing ratio profiles and the obtained precipitable water vapor (PWV) measured by Raman lidar are used to reveal the temporal and spatial variations in water vapor, and the comparisons with the total column water vapor content (TCWV) measured by a sunphotometer validate the daytime variation trend of the water vapor. All-day continuous observations clearly present a consistent variation trend in the water vapor between the sunphotometer and Raman lidar measurements. The correlation analysis between TCWV and PWV at the layers below 850 hPa and below 700 hPa yields a good positive correlation coefficient (>0.75), indicating that PWV determination in the bottom layer by Raman lidar can directly reflect the variations in the total water vapor content. Moreover, different diurnal variation trends in water vapor are also observed, that is, a downward trend from the afternoon to the night, or a tendency of being high in the morning and afternoon and low at noon, demonstrating the high temporal-spatial variation characteristics of water vapor and close correlation with weather changes. The results reflected and validated that the diurnal variation in water vapor is complicated and can be an indicator of the weather to a certain extent.

To evaluate the potential of Raman lidar observations for measuring precipitable water vapor (PWV), PWV variations and distribution characteristics were investigated in Xi’an (34.233°N, 108.911°E), and its comparisons with meteorological parameters were also analysed. Comparisons of lidar PWV with radiosonde PWV verified the ability and accuracy of using Raman lidars for PWV measurements. The diurnal and monthly variation trends in PWV in different layers are first discussed via the statistical analysis of lidar data from November 2013 to July 2016; different proportions of PWV were found in different layers, and the PWV in each layer presented a slight diurnal change trend and consistent seasonal variation, which was relatively rich in summer, less so in spring and autumn, and relatively deficient in winter. Furthermore, correlation analyses between lidar PWV and meteorological parameters are explored. Water vapor pressure and surface temperature revealed the same inter-seasonal oscillation of PWV, with a correlation coefficient of ~0.90. However, incomplete synchronization was found between PWV and relative humidity and precipitation parameters. Higher humidity appeared in the late summer and the beginning of autumn of each year, which was also the case for precipitation and precipitation efficiency. In addition, atmospheric water vapor density profiles and the obtained PWV by Raman lidar are discussed employing a rainfall case, and a comprehensive analysis with meteorological parameters is undertaken. The intensifying characteristics of vertical change in water vapor and the accumulation of PWV in the lower troposphere can be captured by lidar before the onset of rainfall. In contrast to the obvious diurnal change trend, such meteorological parameters as relative humidity, water vapor pressure, and dew-point temperature difference are accompanied with stable trends with a change rate of close to 0 in the rainfall processes; they also show high correlated variations with lidar PWV. Thus, with the advantage of lidar detection, investigation of water vapor profiles and PWV by Raman lidar, and the comprehensive correlation analyses with synchronic meteorological parameters can prove to be good indications of rainfall.