Search

On 6 February 2023 (UTC), an earthquake doublet, consisting of the Mw 7.8 Pazarcik earthquake and the Mw 7.5 Elbistan earthquake, struck south-central Turkey and northwestern Syria, which was the largest earthquake that occurred in Turkey since the 1939 Erzincan earthquake. The faulting model of this earthquake was estimated based on the coseismic InSAR and GPS displacements. In addition, the best-fitting coseismic faulting model indicates that both the Pazarcik earthquake and the Elbistan earthquake were controlled by predominated left-lateral strike-slip motion, with slip peaks of 9.7 m and 10.8 m, respectively. The Coulomb failure stress (CFS) change suggests that the Pazarcik earthquake has a positive effect in triggering the rupture of the seismogenic fault of the Elbistan earthquake. Furthermore, these two main shocks promoted the occurrence of the Mw 6.3 strong aftershock. Additionally, it is found that the 2023 Turkey-Syria earthquake doublet increased the rupture risk of the Puturge segment of the EAF fault and the northern segment of the Dead Sea Fault (DSF). It is crucial to note that the northern segment of the DSF has not experienced a large earthquake in several centuries, highlighting the need for heightened attention to the potential seismic hazard of this segment. Finally, a deformation zone adjacent to the DSF was identified, potentially attributed to the motion of a blind submarine fault. [ABSTRACT FROM AUTHOR]

The ascending and descending InSAR deformations derived from ALOS-2 and Sentinel-1 satellite SAR images and GPS displacements are used to estimate the fault model of the 2018 Mw 6.4 Hualien earthquake. The sinistral strike-slip fault dipping to the west with a high dip angle of 89.4° and a rake angle of 201.7° is considered as the seismogenic fault of this event. This seismogenic fault also triggered the ruptures of the Milun fault, which dips to the east with a dip angle of ~72°, and an unknown west-dipping fault with a dip angle of 85.2°. Two predicted faulting models indicate that the InSAR deformation fields include more postseismic slip than those of the GPS data. The north segment of the Milun fault and west-dipping fault have been triggered by the rupture of the seismogenic fault, but the postseismic slip occurred only in the south segment of the Milun fault. The InSAR-derived co-seismic and postseismic faulting model suggests that the significant slip concentrates at depths of 2.4–15.0 km of the main fault, 0.0–14.0 km of the Milun fault. Only minor slip is detected on the west-dipping fault. The maximum fault slip of ca. 2.1 m is located at the depth of ca. 2.4 km under the Meilun Tableland. The Coulomb failure stress (CFS) change calculated by the co-seismic and postseismic faulting model shows that there is a significant CFS increase in the east of the south segment of the Milun fault, but few of the aftershocks occur in this area, which indicates a high risk of future seismic hazard. [ABSTRACT FROM AUTHOR]