Search

The conventional Diesel cycles engine is now approaching the practical limits of efficiency. The recuperated split cycle engine is an alternative cycle with the potential to achieve higher efficiencies than could be achieved using a conventional engine cycle. In a split cycle engine, the compression and combustion strokes are performed in separate chambers. This enables direct cooling of the compression cylinder reducing compression work, intra cycle heat recovery and low heat rejection expansion. Previously reported analysis has shown that brake efficiencies approaching 60% are attainable, representing a 33% improvement over current advanced heavy duty diesel engine. However, the achievement of complete, stable, compression ignited combustion has remained elusive to date. The challenge is to induct hot high pressure charge air close to top dead centre into the combustion cylinder and then inject and burn the fuel before the piston has travelled significantly down the expansion stroke. In this paper, we report results from a single cylinder split cycle combustion research engine. Stable, rapid combustion was achieved at 800 rpm and 1200 rpm at the retarded timings required for a split cycle engine. The calculated rate of heat release was more rapid than typically observed on conventional compression ignition engine suggesting good mixing of the fuel and air during induction. One dimensional cycle analysis was used to calculate the implications of the test results on the full engine cycle which indicated class leading brake efficiencies approaching and possibly exceeding, 60% are possible from a split cycle engine.