Search

A simple, environmentally friendly and cost-effective nonsurfactant template method was used to synthesize tannic-acid-templated mesoporous silica nanoparticles (TMSNs), and then dopamine functionalized TMSNs (Dop-TMSNs) which was synthesized by a facile and biomimetic coating strategy, was developed as a new sorbent for the removal of Cu 2+ from aqueous solution. The Dop-TMSNs were thoroughly characterized by SEM, TEM, BET, FT-IR and TGA, and the effects of contact time, initial pH, K + and Na + concentrations, co-existing polyvalent metal ions and adsorption-desorption cycle times on the sorption capacity of Dop-TMSNs were studied. It was demonstrated that the maximum adsorption capacity of Cu 2+ by Dop-TMSNs was 58.7 mg/g at pH 5.5, and the sorption reached equilibrium within 180 min. Moreover, the K + and Na + concentrations had a very slight influence on the sorption process and the adsorption capacity of the Dop-TMSNs still remained 89.2% after recycling for four times. All the results indicated that the Dop-TMSNs could be utilized as an excellent sorbent for the sequestration of Cu 2+ .

In this work, we proposed to utilize three-dimensional porous copper foam (CF) as conductive substrate and precursor of in-situ growth CuO nanowires (NWs) for fabricating electrochemical nonenzymatic glucose sensors. The CF supplied high surface area due to its unique three-dimensional porous foam structure, and thus resulted in high sensitivity for glucose detection. The CuO NWs/CF based nonenzymatic sensors presented reliable selectivity, good repeatability, reproducibility, and stability. In addition, the CuO NWs/CF based nonenzymatic sensors have been employed for practical applications, and the glucose concentration in human serum was measured to be 4.96 ± 0.06 mM, agreed well with the value measured from the commercial available glucose sensor in hospital, and the glucose concentration in saliva was also estimated to be 0.91 ± 0.04 mM, which indicated that the CuO NWs/CF owned the possibility for noninvasive glucose detection. The rational design of CuO NWs/CF provided an efficient strategy for fabricating of electrochemical nonenzymatic biosensors.

Motivated by the effect of symmetry breaking in cuprates superconductors YBa 2 Cu 3 O 7 - δ , we employ the renormalized mean-field theory to study the presence of uniform superconducting and charge-ordered states in two anisotropic t–J–U models, either with hopping strength anisotropy or antiferromagnetic interaction anisotropy. In the case of uniform superconducting state, compared with the isotropic t–J–U model with only d x 2 - y 2 -wave superconducting state, there is an additional s-wave superconducting state in the model with hopping strength anisotropy. Meanwhile, the hopping anisotropy may enhance the critical Coulomb interaction U c at the Mott insulator to the Gossamer superconductor transition point, and strong hopping anisotropy may weaken the superconducting state. In the case of a charge-ordered state, hopping anisotropy may suppress the amplitude of the charge density waves and pair density waves, which originate from local Coulomb interactions. These results indicate that the effects of hopping anisotropy and local Coulomb interactions are competitive. Moreover, the antiferromagnetic interaction anisotropy only weakly suppresses the superconducting gap and density wave amplitude. Our results show that the t–J–U model with hopping anisotropy is qualitatively consistent with experimental superconducting pair symmetry and charge density waves in the YBa 2 Cu 3 O 7 - δ system. [ABSTRACT FROM AUTHOR]

Metal microspheres doping porous carbon (MMPC), which was prepared using in-situ pyrolysis reduction strategy, could enhance the thermal conductivity of shape-stabilized phase change material (ss-PCM) prepared by MMPC as the matrix. However, in previous studies that were reported, the preparation of MMPC needed to synthesize porous carbon by pyrolysis firstly, and then porous carbon adsorbed metal ions was pyrolyzed again to obtain MMPC, which was tedious and energy-prodigal. In this study, a one-step pyrolysis strategy was developed for the synthesis of MMPC through the pyrolyzation of wheat bran adsorbed copper ions, and the copper microspheres doping wheat bran biochar (CMS-WBB) was prepared. The CMS-WBB was taken as the supporter of stearic acid (SA) to synthesize the ss-PCM of SA/CMS-WBB. The study results about the thermal properties of SA/CMS-WBB demonstrated that the introduction of copper microspheres could not only improve the thermal conductivity of SA/CMS-WBB, but also could increase the SA loading amount of wheat bran biochar. More importantly, the CMS-WBB could be obtained by only one-step pyrolysis, which greatly simplified the preparation process and saved energy consumption. Furthermore, the raw material of wheat bran is a kind of agricultural waste, which is abundant, cheap and easy to obtain. Hence, the SA/CMS-WBB synthesized in this study had huge potentialities in thermal management applications, and a simplified method for improving the thermal properties of ss-PCMs was provided. [ABSTRACT FROM AUTHOR]

Copper microsphere hybrid mesoporous carbon (MPC-Cu) was synthesized by the pyrolysis of polydopamine microspheres doped with copper ions that were prepared using a novel, facile and simple one-step method of dopamine biomimetic polymerization and copper ion adsorption. The resulting MPC-Cu was then used as a supporter for polyethylene glycol (PEG) to synthesize shape-stabilized phase change materials (PEG/MPC-Cu) with enhanced thermal properties. PEG/MPC-Cu was studied by scanning electron microscopy, X-ray diffraction, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, thermogravimetric analysis, differential scanning calorimetry and thermal constant analysis. The results demonstrated that the thermal conductivity of PEG/MPC-Cu was 0.502 W/(m K), which increased by 100% compared to pure PEG [0.251 W/(m K)]. The melting enthalpy of PEG/MPC-Cu was 95.98 J/g, indicating that PEG/MPC-Cu is a promising candidate for future thermal energy storage applications. In addition, the characterization results suggested that PEG-MPC-Cu possessed high thermal stability. Therefore, the method developed in this paper for preparing shape-stabilized phase change materials with improved thermal properties has substantial engineering application prospects. [ABSTRACT FROM AUTHOR]