Search

Abstract Predictors of rebound after correction of coronal plane deformities using temporary hemiepiphysiodesis (TH) are not well defined. The following research questions were tested: (1) Is the dynamic knee joint load useful to improve rebound prediction accuracy? (2) Does a large initial deformity play a critical role in rebound development? (3) Are BMI and a young age risk factors for rebound? Fifty children and adolescents with idiopathic knee valgus malalignment were included. A deviation of the mechanical femorotibial angle (MFA) of ≥ 3° into valgus between explantation and the one-year follow-up period was chosen to classify a rebound. A rebound was detected in 22 of the 50 patients (44%). Two predictors of rebound were identified: 1. reduced peak lateral knee joint contact force in the first half of the stance phase at the time of explantation (72.7% prediction); 2. minor initial deformity according to the MFA (70.5% prediction). The best prediction (75%) was obtained by including both parameters in the binary logistic regression method. A TH should not be advised in patients with a minor initial deformity of the leg axis. Dynamic knee joint loading using gait analysis and musculoskeletal modeling can be used to determine the optimum time to remove the plates.

Abstract Preparation of the femoral proximal medullary cavity by reaming is essential for intramedullary nail osteosynthesis and hip revision arthroplasty. The use of reamers sometimes exerts high torsional forces on the bone. Design and direction of rotation of the reamer are potential influencing factors. The aim of this biomechanical study is to evaluate the best combination of a right- or left-cutting reamer with a clockwise- or counterclockwise-rotating insert in terms of preparation and safety. Right- and left-cutting reamers with conical design were each introduced into five synthetic femurs in both clockwise and counterclockwise rotation with constant feed force. A specially constructed test system was used for this series of tests, with which the respective intramedullary channel were reamed step by step. This was then used to determine the required torque. In addition, the feed rate measurement was analyzed using a modified digital caliper. The feed rates of the reamers with rotation in the same direction as the cutting direction were significantly increased compared to rotation in the opposite cutting direction (CCRLC vs. CCRRC 76.8 ± 9.0 mm/s vs. 25.2 ± 8.3 mm/s and CRRC vs. CRLC 54.3 ± 12.3 mm/s vs. 19.3 ± 0.6 mm/s; p